CRT-Based Clock Synchronization for Millimeter-Wave Communication with Asymmetric Propagation Delays

Shufeng Tan,Qifei Wang,Ziwei Wan,Fei Luo

DOI: https://doi.org/10.3390/electronics13132441

IF: 2.9

2024-06-22

Electronics

Abstract:The rapid advancement of millimeter-wave communication technology has presented new challenges for time synchronization, driven by the need for high-speed and low-latency data transmission. Ethernet synchronization technologies, such as Precise Time Protocol (PTP), have emerged to overcome the limitations of point-to-point architecture and enable precise synchronization across multiple devices. A key drawback of conventional PTP is its reliance on symmetric packet exchange delays, which may not hold in real-world scenarios where there is relative mobility between master and slave nodes, leading to asymmetric propagation delays and clock offset errors. To address this issue, a novel clock synchronization protocol that integrates Chinese Remainder Theory (CRT) has been proposed. This protocol enhances conventional PTP by incorporating distance estimation based on CRT using multi-carrier phase measurement. By combining a coarse estimation of one-way propagation delay from conventional PTP with a fine estimation of remainder distance from CRT, the protocol accurately determines the distance between master and slave nodes, reducing motion errors and enhancing clock synchronization accuracy. Simulation results indicate that the Root Mean Square Error (RMSE) of distance estimation remains below 10−5 meters, with a corresponding motion time error of approximately 0.01 picosecond.

engineering, electrical & electronic,computer science, information systems,physics, applied

What problem does this paper attempt to address?

The paper primarily addresses the issue of clock synchronization in millimeter-wave communication systems, particularly when there is asymmetric propagation delay. Specifically, the paper focuses on how to improve the accuracy of clock synchronization in the presence of asymmetric propagation delays caused by relative motion between nodes.

Traditional Precision Time Protocol (PTP) assumes that the round-trip propagation delay between the master and slave nodes is symmetric. However, this assumption often does not hold in practical scenarios, especially when there is relative motion between the nodes. This asymmetry can lead to clock offset estimation errors, thereby affecting the accuracy of clock synchronization. To address this issue, the paper proposes a novel clock synchronization protocol based on the Chinese Remainder Theorem (CRT).

The main contributions of this protocol are as follows:
1. **Combining Traditional PTP with CRT**: By combining the coarse one-hop propagation delay estimation provided by traditional PTP with the fine residual distance estimation based on CRT, accurate estimation of asymmetric propagation delays is achieved.
2. **Distance Estimation**: Utilizing multi-carrier phase measurement techniques in conjunction with CRT for distance estimation effectively overcomes the limited range problem of CRT theory.
3. **Motion Error Compensation**: By accurately estimating the actual distance between the master and slave nodes, motion errors can be precisely determined and compensated for, thereby improving the accuracy of clock synchronization.
4. **No Need to Modify Traditional PTP Structure**: This method only requires the use of signals containing multiple carriers when sending synchronization messages, without the need to modify the traditional PTP time synchronization process, thus reducing implementation difficulty and resource consumption.

Simulation results show that this method can significantly reduce the root mean square error (RMSE) of distance estimation, and the corresponding motion time error is also very small, approximately 0.01 picoseconds, indicating that this scheme is very effective in improving clock synchronization accuracy.