Controllable Heterogeneous Seeding Induced Crystallization for High‐Efficiency FAPbI3‐Based Perovskite Solar Cells Over 24%

Hengkai Zhang,Zhiwei Ren,Kuan Liu,Minchao Qin,Zehan Wu,Dong Shen,Yaokang Zhang,Hrisheekesh Thachoth Chandran,Jianhua Hao,Chun‐sing Lee,Xinhui Lu,Zijian Zheng,Jinsong Huang,Gang Li

DOI: https://doi.org/10.1002/adma.202204366

IF: 29.4

2022-07-26

Advanced Materials

Abstract:The addition of small seeding particles into a supersaturated solution is one among the most effective approaches to obtain high‐quality semiconductor materials via increased crystallization rates. However, limited study was conducted on this approach for the fabrication of perovskite solar cells. Here, we propose a new strategy – "heterogeneous seeding‐induced crystallization (hetero‐SiC)" to assist the growth of FAPbI3‐based perovskite. In this work, the (t‐Bu)2PMeHBF4 is directly introduced into the precursor which forms a low solubility complex with PbI2. The low solubility complex can serve as the seed to induce crystallization of perovskite during the solvent evaporation process. Various in situ measurement tools are used to visualize the hetero‐SiC process, which has been shown to be an effective way of manipulating the nucleation and crystal growth of perovskite. The hetero‐SiC greatly improves the film quality, reduces the film defects, and suppresses the non‐radiative recombination. The hetero‐SIC proof‐of‐concept device exhibits outstanding performance with 24.0% PCE, well over the control device with 22.2% PCE. Additionally, hetero‐SiC PSC stability under light illumination is enhanced and retains 84 percent of its initial performance after 1400 hours of light illumination. This article is protected by copyright. All rights reserved

materials science, multidisciplinary,chemistry, physical,physics, applied, condensed matter,nanoscience & nanotechnology