Filtration of Particulates and Emulsions with a Pleated, Thin Channel, Cross-Flow Module

G. B. Tanny,D. Hauk

DOI: https://doi.org/10.1080/01496398008068486

IF: 2.799

1980-04-01

Separation Science and Technology

Abstract:The pleated thin channel crossflow module represents a novel flat sheet membrane configuration combining the modular advantages of hollow fiber design with the hydrodynamics of plate and frame units containing turbulence promoting elements. It consists of a circular array of parallel pleated thin channels, each of whose inner wall is a membrane supported by a porous backing resting on a central product drain tube. The outer flexible wall is separated from the membrane by a turbulence promoting spacer and serves to create the flow channel, without fulfilling a direct filtrative purpose. The design allows operation at elevated particulate levels and is highly suited to microfiltration of stray matter and bacteria from aqueous solutions to be injected into well heads for enhanced oil recovery. Data are presented for 0.45 and 0.2 μm pore size membrane modules containing 3.3 ft2 of membrane area and operating on dispersions of standard particulates of known size distribution (80 μm to 0.2 μm). Effects of filtration mode (i.e., constant pressure or constant permeate rate), and crossflow velocity were examined at particulate concentrations from 250 to 800 ppm. For seperation involving paraffinic oil/water emulsions, modules are either fabricated with ultrafiltration (UF) membrane, or a dynamically formed membrane is created on the microporous support. The latter approach was used to purify waste textile scouring washwater at 60°, thereby recovering both water and energy. Waste scouring water, containing ±1200 ppm of emulsified total organic carbon (TOC), 500 ppm of freon extractable hydrocarbon, and a turbidity of 66 nephalometric turbidity units (NTU) was ultrafiltered at 50 to 60°C with a dynamically formed silic a membrane at an average pressure of 17 psi and 1.6 gpm crossflow in a unit containing 1 ft 2 of 0.2 pm Acropor support. The product flow rate was 35 to 50 gpd and contained 400 ppm TOC with 125 ppm freon extractable hydrocarbon and a turbidity of 0.5 NTU. Yarn samples scoured with recovered scouring water showed no difference in their dyeability.

engineering, chemical,chemistry, multidisciplinary