Abstract:With the continuous innovation and improvement of electronic information and systems, the transmission power in the equipment is also increasing. For the propagation of high-power microwaves, not only the transmission characteristics of high-power microwaves should be considered, but also the protection measures should be taken to prevent the damage caused by excessive pulses on the back-end equipment. In this article, the characteristics of waveguide plasma limiter are studied based on the plasma formed by low pressure microwave gas discharge, which reflects and absorbs electromagnetic waves. At the same time, in response to the potential power leakage problem of single-stage plasma limiters in protecting high-power microwaves, a protective device is proposed for the combination of plasma limiters and PIN limiters in rectangular waveguides. When the incident microwave intensity is strong, the electronic components are protected from burning by plasma. When the front-end plasma limiter fails to exert its effect and causes power leakage, the transmitted microwave energy is attenuated by the subsequent PIN diode limiter circuit, causing its strength to fall below the safety threshold. This limiter system model can be controlled and described by the electromagnetic (EM) fields, plasma physics and PIN equivalent circuit model. In the multi-physics cascaded waveguide limiter system, the spectral-element time-domain (SETD) method is used for system integration and self-consistent simulation analysis. The results show that the limiting performance of the cascaded limiter is much better than that of the single-stage plasma limiter under the action of HPM pulses. This research provides theoretical guidance for the use of plasma limiting devices to protect against high-power microwave damage.

X-Band Ferrite Microstrip Limiter Based on Improved Nonlinear Loss Model for High-Power Microwave Application

Improved circuit model for coplanar-waveguide to microstrip-line transition on silicon substrate

Parallel-pumped nonlinear loss effects for polycrystalline yttrium iron garnet in the high-power microwave environment

FDTD modeling of 3D metal-LTCC structures for RF(MM)ICs

Frequency-Dependent Maximum Average Power-Handling Capabilities of Single and Edge-Coupled Microstrip Lines on Low-Temperature Co-Fired Ceramic (ltcc) Substrates

Simulation Analysis of High Power Microwave Propagation Properties in a Simplified Plasma Limiter

Simulation of Simplified Cascade Waveguide Plasma Limiter under High Power Microwave

Practical Model for Metamaterials in Wireless Power Transfer Systems

Active Microwave Metamaterials Incorporating Ideal Gain Devices

Impact of Nonlinear Effects on the Silicon-Based Waveguides and Microring Resonators

New Design Method Based on High Loss Transmission Line Theory for Microwave-Heating

Miniaturised X-band balanced microwave limiter based on thin film hybrid integrated circuit technology

Theoretical Research on the Performance of a Practical Helix Travelling Wave Tube

The Integrated Design of RF Front-End Filter and Limiter

Strong And Low-Loss Dual-Resonant Metamateiral In The Terahertz Regime

Theoretical investigations on nonlinear couplings of high power microwaves into the cavity with a hole

High Power X-Band Monolithic GaAs p-i-n Balanced Limiter

An Improved Core Loss Model of Ferromagnetic Materials Considering High-Frequency and Nonsinusoidal Supply

Design of the Compact Multimode Feeds with High Power Capacity

An Electromagnetic-Plasma Fluid Model Simulation of Waveguide Plasma Limiter Filled with Different Easily Ionized Inert Gas

Improved Spice Simulation of Dynamic Core Losses for Ferrites With Nonuniform Field and Its Experimental Validation