Abstract:The application of additive manufacturing (AM) is gradually extending to different industrial sectors. Most additively manufactured metallic components typically exhibit an inherent columnar grain structure, the control of which has been a challenging issue. In this study, the microstructures of the characteristic zones (heat-affected zone and transition zone) were controlled by adjusting the deposition strategy and arc mode during wire arc additive manufacturing (WAAM) of NiTi alloy. Compared to the sample fabricated by cold metal transfer (CMT) mode, the oscillating (O) sample shows a higher tensile strength of 793.6 MPa, while the pulsed (P) sample shows a better elongation of 5.8%. The high strength of the O samples is mainly due to the significantly lower aspect ratio of its columnar grains, while fine equiaxed grain structure in the transition zone of the P samples is responsible for the better plasticity. Different microstructures in the characteristic zones can be tailored by combining the forced melt flow, pulse frequency and undercooling, which provides vast freedom for the associated mechanical properties control. Our work provides a new strategy to regulate the microstructure and thus mechanical properties of additively manufactured NiTi alloys.

Modulation of characteristic zones in NiTi alloys fabricated via wire arc additive manufacturing