Abstract:Based on a complex of metallographic and X-ray phase studies for the conditions of EVRAZ ZSMK, which is a leading domestic manufacturer of railway rails, the nature of characteristic defects of rails of metallurgical origin has been determined. These defects, which are the cause of rejection of rails during ultrasonic quality control in the flow of rail-block mill, are stratifications, in the localities of which accumulations of silicate, alumina and sulfide non-metallic inclusions are concentrated; at the same time, these defects in the vast majority of cases are located in the neck of the rail profiles. Analysis of contamination with non-metallic inclusions of suitable rails of the current production of EVRAZ ZSMK showed that, unlike the locations of defects in rejected rails, alumina non-metallic inclusions have an extremely low concentration, while manganese sulfides and silicate inclusions have the highest relative concentration. Based on the results obtained, technological measures were developed, pilot-industrial and implemented to improve the production technology of rail steel in the conditions of the electric steelmaking workshop of EVRAZ ZSMK. In order to reduce the concentration of oxide nonmetallic inclusions in rail steel, a new technology of ladle treatment of steel using a low-ash carburizer and calcium carbide for slag deoxidation has been developed. To reduce sulfide inclusions contamination, measures have been implemented to ensure the sulfur content in the finished steel at a level of no more than 0.008%. The optimization of the modes of electromagnetic mixing in the mold and the temperature regimes of continuous casting of steel was carried out, which also had an effect on reducing the concentration of non-metallic inclusions in continuously cast billets of rail steel and finished rails. The introduction of a set of these technological solutions and measures allowed to reduce the rejection of rails for internal defects from 7% to less than 2%

Nature Detection of Internal Defects in Railroad Rails Produced by EVRAZ ZSMK Company Using Ultrasonic Control in Mill Flow

Development of technological solutions to improve the quality of railway rails by improving the technology of smelting, out-of-furnace processing and continuous casting of rail electric steel.

Ultrasonic Guided Wave-Based Switch Rail Monitoring Using Independent Component Analysis

Research on the rail waist defect testing with laser-EMAT ultrasonic and signal processing

Testing the Spalling Defects on Rail Tread with Laser EMAT Ultrasonic

The Possibility of Detecting Defects in Rail Foot by the MFL Method

Application of eddy current testing in the quantitative evaluation of the rail cracks

Detection of Rail Defects Using NDT Methods

Defect Detection inside a Rail Head by Ultrasonic Guided Waves

Experimental Study of Static and Dynamic Loading Effects on Guided Wave-Based Intelligent Monitoring of Welded Rail Joints

Rail Surface Defect Detection and Analysis Using Multi-Channel Eddy Current Method Based Algorithm for Defect Evaluation

Use of Longitudinal Critically Refracted Waves to Determine Residual and Temperature Stresses in Rails

Evaluation of Mechanisms for Strengthening of Surface Layers of Long Rails in Different Directions Under Continuous Operation

A NEW CLASSIFICATION OF RAIL DEFECTS

PROCESSES OF WELDED JOINT STRUCTURE FORMATION DURING ELECTRIC RESISTANCE WELDING OF RAILWAY RAILS

Detection and Classification System for Rail Surface Defects Based on Eddy Current

Study of Melting Methods by Electric Resistance Welding of Rails

Modelling and simulation of ultrasonic inspections in welded rails subjected to practical environmental conditions

Evaluation of typical rail defects by induction thermography: experimental results and procedure for data analysis during high-speed laboratory testing

Research on Forward Problem of Rail Detection Based on Magnetoacoustic Coupling

Rolling Contact Fatigue Damage in Welded Rail Steel Joints