Abstract:Extended defects such as dislocations and grain boundaries have a strong influence on the performance of microelectronic devices and on other applications of semiconductor materials. However, it is still under debate how the defect structure determines the band structure, and therefore, the recombination behavior of electron-hole pairs responsible for the optical and electrical properties of the extended defects. The present paper is a survey of procedures for the spatially resolved investigation of structural and of physical properties of extended defects in semiconductor materials with a scanning electron microscope (SEM). Representative examples are given for crystalline silicon. The luminescence behavior of extended defects can be investigated by cathodoluminescence (CL) measurements. They are particularly valuable because spectrally and spatially resolved information can be obtained simultaneously. For silicon, with an indirect electronic band structure, CL measurements should be carried out at low temperatures down to 5 K due to the low fraction of radiative recombination processes in comparison to non-radiative transitions at room temperature. For the study of the electrical properties of extended defects, the electron beam induced current (EBIC) technique can be applied. The EBIC image reflects the local distribution of defects due to the increased charge-carrier recombination in their vicinity. The procedure for EBIC investigations is described for measurements at room temperature and at low temperatures. Internal strain fields arising from extended defects can be determined quantitatively by cross-correlation electron backscatter diffraction (ccEBSD). This method is challenging because of the necessary preparation of the sample surface and because of the quality of the diffraction patterns which are recorded during the mapping of the sample. The spatial resolution of the three experimental techniques is compared.

Defect imaging and detection of precipitates using a new scanning positron microbeam

Wide-Field Spectral Super-Resolution Mapping of Optically Active Defects in Hexagonal Boron Nitride.

Defect detection in additively manufactured AlSi10Mg and Ti6Al4V samples using laser ultrasonics and phase shift migration

Three-dimensional imaging of individual point defects using selective detection angles in annular dark field scanning transmission electron microscopy

Defect detection by multi-axis infrared process monitoring of laser beam directed energy deposition

Imaging Threading Dislocations and Surface Steps in Nitride Thin Films Using Electron Backscatter Diffraction

Advanced Detector Signal Acquisition and Electron Beam Scanning for High Resolution SEM Imaging.

Defect-based analysis of the laser powder bed fusion process using X-ray data

A66Pathways to exploit the multi-spot scanning strategy in electron beam additive manufacturing for control of microstructure and defect density

Direct Detection of Microdefects in Beta-Barium Metaborate Bulk Crystals by Light-Scattering Tomograph

Revealing nano-scale lattice distortions in implanted material with 3D Bragg ptychography

Non-contact imaging of subsurface defects using a scanning laser source

Imaging of Optically Active Defects with Nanometer Resolution

Laser ultrasonic detection for defects of LAM components based on variable time window intensity mapping with adaptive 2σ thresholds

In-Situ Monitoring for Defect Identification in Nickel Alloy Complex Geometries Fabricated by L-PBF Additive Manufacturing

In situ X-ray imaging of defect and molten pool dynamics in laser additive manufacturing

In situ Imaging of Precipitate Formation in Additively Manufactured Al-Alloys by Scanning X-ray Fluorescence

Imaging low-energy positron beams in real-time with unprecedented resolution

Comprehensive Characterization of Extended Defects in Semiconductor Materials by a Scanning Electron Microscope

3D-imaging of selective laser melting defects in a Co-Cr-Mo alloy by synchrotron radiation micro-CT

Defect dynamics studies during heat treatments in plastically deformed metals predicted for nuclear applications