Abstract:Alternative fuels can be produced from both non-edible feedstocks and edible crops. The higher production costs and contaminating nature of vegetable biofuels, which cause engine component failure, make it conceivable to encourage the synthesis of biodiesel from non-edible sources. One of the most widely utilized alternative fuels is Jatropha biofuel, which has performance levels comparable to diesel fuels and can be used with CI (Compression Ignition) engines without any modifications. However when it comes to oxidative stability properties that impact shelf life and commercialization, the majority of biodiesels-including Jatropha-are lacking. Therefore, the objective of this study was to enhance the oxidative stability and other physicochemical parameters, such performance and emission characteristics, of Jatropha biodiesel with diesel blends by adding additives like DEE (diethyl ether) and MA (moringa oleifera antioxidant). The seeds of jatropha and moringa were harvested by hand and then mechanically extracted with a screw press. A conical flask containing the precisely weighed amount of oil is filled with 50 mL of neutral alcohol. The combination is then heated for an hour using a water condenser over a bath. Using phenolphthalein indicator, the contents are titrated with KOH solution after cooling. Weight of oil taken (w)/volume of KOH used (mL) × normality of KOH is the formula used to determine the acidity value of jatropha oil. It is therefore below the minimum level set by ASTM D 675, which is 2.5 mg KOH/g. Methanol was used in the transesterification process to produce biodiesel, and potassium hydroxide (KOH) was used as a catalyst. Then, using 5 % DEE and 10 % MA additives, the physicochemical properties of jatropha biodiesel-such as density, kinematics viscosity, calorific value, and oxidative stability-were characterized. The percentage of improvement of the biodiesel's mentioned properties with these additives was 0.68 %, 2.8 %, 0.73 %, and 33.8 %, respectively. The brake thermal efficiency (BTE) of B40MA10DEE05D45 increased by 8.52 % whereas the brake specific fuel consumption (BSFC) of B50MA10DEE05D35, which is Made up of 44 % diesel, 50 % jatropha biodiesel, 5 % DEE, and 10 % MA fuels, declined by 5.14 %. As a result of these additions, the blended fuel's CO, HC, and NOx emissions were reduced by 3.51 %, 2.25 %, and 8.64 %, respectively. Therefore, a 20 % blend of Jatropha biodiesel and diesel containing antioxidants from Moringa can be used in compression ignition engines without the need for engine modifications and with high oxidation stability.

Comprehensive Comparative Study of the Durability Wear Assessment of a Diesel Engine Fuelled with Jatropha Seed Oil and Diesel Fuel and Its Troubleshooting and Scheduled Maintenance

Comparative analysis of compression ignition engines performance and emission characteristics devouring edible and nonedible oil biodiesel

An investigation of the longevity wear assessment during the utilisation of biofuel-diesel blends in a diesel engine: a case study of crude palm and crude jatropha oil

A study on the performance and emission of diesel engine with Jatropha biodiesel and its blends at different engine load

Assessment and usability of Jatropha biodiesel blend with phenolic antioxidant to control NOx emissions of an unmodified diesel engine

Comparative thermal assessment and emission analysis of various green biodiesel from novel feedstocks for CI engines: a sustainable approach towards emission reduction

Experimental and Theoretical Investigation on the Performance of a Biodiesel-Powered Engine from Plant Seeds in Egypt

Experimental Studies on the Jatropha-Biogas Dual Fuel Engine

Assessment of performance and emission characteristics of CI engine using tyre pyrolysis oil and biodiesel blends by nano additives: An experimental study

Effect of oxyhydrogen as on energy, exergy and sustainability analysis of a diesel engine fueled with palm oil biodiesel

Performance and Emission Analysis of Biodiesel Blends in a Low Heat Rejection Engine with an Antioxidant Additive: An Experimental Study

Experimental investigation on treated transformer oil (TTO) and its diesel blends in the diesel engine

Experimental Analysis of Hydrogen Addition at Varying Injection Opening Pressures on a Dual-Fuel Diesel Engine Operating with Diesel and Cottonseed Oil

Assessment of the Engine Vibration and Noise Characteristics of an Unmodified Direct Injection Engine Powered With Non-Feedstock Citrullus lanatus Seed Oil

Impact of hydrogen-assisted combustion in a toroidal re-entrant combustion chamber powered by rapeseed oil/waste cooking oil biodiesel

Environmental impact of VCR diesel engine characteristics using blends of cottonseed oil with nano additives

Influence of phenolic antioxidant additives on performance and emission characteristics of diesel engine fuelled with Jatropha biodiesel: A sustainable hybrid model using RSM and ANFIS

Performance and emissions characteristics of a common rail direct injection diesel engine powered by ignition enhancer-biodiesel blends

Optimization of Combustion Characteristics of Diesel Engine Fueled by Biofuels and Its Diesel Blends with Additive Titanium Dioxide Nano-Particles

Evaluating the effect of diethyl ether and moringa oleifera antioxidant additives on the performance and emission characteristics of jatropha biodiesel-diesel blended fuel on CI engine - An experimental investigation

Straight and Waste Vegetable Oil in Engines: Review and Experimental Measurement of Emissions, Fuel Consumption and Injector Fouling on a Turbocharged Commercial Engine