Abstract:Improving the contamination resistance of membranes is one of the most effective ways to address the short service life of membranes. While preparing the membrane system structure, doping nanoparticles into the polymer matrix is beneficial to the preparation of high-performance membranes. To develop a new structure for membrane contamination protection, in this study, a novel asymmetric polyamide 66 composite ultrafiltration (UF) membrane was fabricated by incorporating different masses (ranging from zero to 0.5 wt.%) of graphene oxide (GO) into the polyamide 66 microporous substrate, using formic acid and propylene carbonate as solvents. The effects of GO doping on the morphology, microporous structure and surface of ultrafiltration membranes were investigated by atomic force microscopy (AFM), scanning electron microscopy (SEM), integrated thermal analysis (DSC) and contact angle (CA). In addition, pure water flux, bovine serum albumin (BSA) rejection and contamination resistance were measured to evaluate the filtration performance of different membranes. The overall performance of all the modified membranes was improved compared to pure membranes. The results of contact angle and permeation experiments showed that the addition of GO improved the hydrophilicity of the membrane, but reduced the permeability of the membrane. The minimum flux was only 3.5 L/m2·h, but the rejection rate was 92.5%. Most noteworthy was the fact that GO further enhanced the anti-pollution performance of the membranes and achieved a remarkable performance of 91.32% when the GO content was 0.5 wt.%, which was 1.36 times higher than that of the pure membrane. Therefore, optimal performance was achieved. Furthermore, the UF membrane made of composite substrate offers a promising solution for the development of long-life ultrafiltration membranes with better stability, high-cost efficiency and adequate chemical durability.

Inkjet printing of graphene oxide and dopamine on nanofiltration membranes for improved anti-fouling properties and chlorine resistance

Impact of Graphitic Carbon Nitride/polydopamine on Permeance and Antifouling Performance of Reverse Osmosis Membranes

Graphene Oxide Based Membrane Intercalated by Nanoparticles for High Performance Nanofiltration Application

Carboxyl-functionalized graphene oxide polyamide nanofiltration membrane for desalination of dye solutions containing monovalent salt

Bio-inspired Fabrication of Anti-fouling and Stability of Nanofiltration Membranes with a Poly(dopamine)/Graphene Oxide Interlayer

Graphene Oxide-Based Membranes Intercalated with an Aromatic Crosslinker for Low-Pressure Nanofiltration

Graphene oxide-based layer-by-layer nanofiltration membrane using inkjet printing for desalination

“Mix-Then-On-Demand-Complex”: In Situ Cascade Anionization and Complexation of Graphene Oxide for High-Performance Nanofiltration Membranes

Enhancing the Dye-Rejection Efficiencies and Stability of Graphene Oxide-Based Nanofiltration Membranes via Divalent Cation Intercalation and Mild Reduction

Functionalised graphene oxide-based nanofiltration membranes with enhanced molecular separation performance

Effect of poly(2-(dimethylamino)ethyl methacrylate) brush-grafted graphene oxide on polyamide layer formation and nanofiltration performance

Graphene oxide-chitosan coated PVDF adsorptive microfiltration membrane: Enhancing dye removal and antifouling properties

Graphene Oxide Polypiperazine-Amide Nanofiltration Membrane for Improving Flux and Anti-Fouling in Water Purification

Chemically Cross-Linked Graphene Oxide as a Selective Layer on Electrospun Polyvinyl Alcohol Nanofiber Membrane for Nanofiltration Application

A Novel Thin-Film Nanocomposite Nanofiltration Membrane by Incorporating 3D Hyperbranched Polymer Functionalized 2D Graphene Oxide

A Membrane with Strong Resistance to Organic and Biological Fouling Using Graphene Oxide and D-Tyrosine as Modifiers

Improving Permeability and Fouling Resistance of GO Hydrophilic/hydrophobic Janus Membrane by Polyether Amine Crosslinking for Membrane Distillation of Dye Wastewater

Graphene Oxide Modified Polyamide 66 Ultrafiltration Membranes with Enhanced Anti-Fouling Performance

Reduced Graphene Oxide-Nh 2 Modified Low Pressure Nanofiltration Composite Hollow Fiber Membranes with Improved Water Flux and Antifouling Capabilities

Fabrication of a novel composite nanofiltration membrane with effective treating dye wastewater via integration of phase inversion and interfacial polymerization

Inkjet printed single walled carbon nanotube as an interlayer for high performance thin film composite nanofiltration membrane