Abstract:The modeling of flow and heat transfer in porous media systems has always been a challenge, and the extended Darcy transport models are used for macro-level analysis. However, these models are subjected to the limitations depending upon the porous geometry such as pore size, pore type, effective porosity, tortuosity, permeability, and the flow characteristics. The forced convective flow of an incompressible viscous fluid through a channel filled with four different types of porous geometries constructed using the Triply Periodic Minimal Surface (or TPMS) model is presented in this study. Four TPMS lattice shapes, namely Diamond, I-WP, Primitive, and Gyroid, are created with same volume fraction of solid subdomain as 0.68 (or void fraction as 0.32). Using different configurations for the solid subdomain by treating it as (a) solid, (b) fluid, and (c) porous zone, three different classes of porous structures are further generated for each TPMS lattice. The present study is executed with the objective to investigate the effect of shape–morphology, tortuosity, microporosity, and effective porosity on permeability and inertial drag factor. A pore-scale direct numerical simulation approach is performed for the first two types of porous media by solving the Navier–Stokes equations. The specific microporosity is quantitatively induced in the solid subdomain where Darcy–Forchheimer equation is solved, whereas the Navier–Stokes equations are solved for the void subdomain in the third type of porous media. The results reveal that Darcy flow regime exists up to the mean velocity value of U < 0.0025 m/s (Re < 10) for all the cases discussed here, and it deviates at the higher mean velocity. The conductance to the flow shown by Darcy number has the maximum and minimum values for the Primitive Type 2 and I-WP Type 1 cases. The inertial drag coefficient is minimum in Diamond lattice and maximum in Primitive lattice at lower porosity (0.32), while Primitive lattice has minimum and I-WP lattice has maximum value of inertial drag coefficient for higher porosity (~ 1).

Engineering of polydisperse porous media for enhanced fluid flows through systematic topology tuning via differentiable direct numerical simulation

Tailoring porous media for controllable capillary flow

PoroFluidics: deterministic fluid control in porous microfluidics

Control of flow behavior in complex fluids using automatic differentiation

Multi-objective topology optimization and flow characteristics study of the microfluidic reactor

Topological optimization for tailored designs of advection-diffusion-reaction porous reactors based on pore scale modeling and simulation

Flow turbulence topology in regular porous media: From macroscopic to microscopic scale with direct numerical simulation

Topology optimization of surface flows

Fluidic Topology Optimization with an Anisotropic Mixture Model

Performance analysis and multi-objective optimization for tubes partially filled with gradient porous media

Effect of viscous shearing stresses on optimal material designs for flow of fluids through porous media

Heterogeneously Engineered Porous Media for Directional and Asymmetric Liquid Transport

Effective Rheology of Two-Phase Flow in Three-Dimensional Porous Media: Experiment and Simulation

Tuning capillary flow in porous media with hierarchical structures

Preferential Flow Control in Heterogeneous Porous Media by Concentration-Manipulated Rheology of Microgel Particle Suspension

Tunable Morphology of Monodisperse Polymer Particles with Microfluidics

Flow Characterization in Triply Periodic Minimal Surface (TPMS)-Based Porous Geometries: Part 1—Hydrodynamics

Pore-Scale Flow Characterization of Polymer Solutions in Microfluidic Porous Media

Numerical analysis of the entry flow for continuous shear thickening fluids in circular microtubes

Simplified level set discrete element modeling of particle suspension flows in microfluidics: clogging statistics controlled by particle friction and shape

Real Porous Media: Local Geometry and Macroscopic Properties