Abstract:Mineral dissolution in fractures is largely affected by the flow field within the fracture opening. The flow field maintains transport of the dissolved solutes and influences the concentration gradient and thermodynamic driving force for the mineral dissolution. In this study, we focus on investigating two factors that influence mineral dissolution in fractures: fracture wall roughness and interporosity fluid exchange or the flux through the fracture walls. The classical cubic law for the flow in parallel-plate channels cannot describe the flow in a fracture with rough permeable walls. The wavy, irregular shape of the rough boundaries can result in local flow features and might cause a shift of the overall flow and dissolution regime. At low Reynolds numbers, roughness simply increases the surface area available for mineral dissolution. Moreover, at higher Reynolds numbers, the inertial effects become important and the non-linear flow, flow instabilities, and reverse flow will form. With the creation of eddies and vorticities in the area adjacent to the walls, a flow dead zone forms that reduces the reactive surface area. In the presence of interporosity fluid exchange between the fracture and its surrounding rock, the non-zero fluid velocity on the fracture walls influences the local concentration gradient. In addition, the newly introduced fluid may facilitate or suppress the fracture wall mineral dissolution depending on its composition. This work highlights the compound effect of roughness and fluid flux through the walls on fracture mineral dissolution. For this purpose, the asymptotic solutions of the steady-state Navier–Stokes equations with non-zero velocity on the borders are used to determine the velocity field within the fracture opening. The quadratic and cubic corrections to Darcy’s law are expected as a result of the wall roughness and the flow through the walls. The flow field is coupled with a transport module and a geochemical model (PHREEQC). As a test case, we investigate calcite dissolution in a single fracture at a different influx rate. For each flow rate, a flat fracture and two sets of rough profiles with and without the permeable walls were compared. The simulation results showed that compared to impermeable walls, the pervious walls result in a non-uniform non-periodic mineral dissolution along the fracture, which is more focused at the inlet. At low Reynolds numbers, the hotspots of dissolution are slightly shifted from the smaller cross sectional area to the larger cross sectional area. The effective reaction rate for mineral dissolution of fracture walls increases with an increase in fracture surface roughness. It is shown that at low Reynolds numbers, the permeable fracture walls can improve the effective reaction rate significantly. At relatively larger Reynolds numbers, the impact of flux through the walls on the effective reaction rate is less important, but for some roughness profiles, still not negligible.

Investigation of coupled processes in fractures and the bordering matrix via a micro‐continuum reactive transport model

A 2.5d Reactive Transport Model for Fracture Alteration Simulation

Reactive Transport Simulation of Fracture Channelization and Transmissivity Evolution

Microcontinuum approach to multiscale modeling of multiphase reactive flow during mineral dissolution

Lawrence Berkeley National Laboratory Recent Work Title A 2 . 5 D Reactive Transport Model for Fracture Alteration Simulation

Multi-scale Model of Reactive Transport in Fractured Media: Diffusion Limitations on Rates

Fracture Evolution in Multimineral Systems: the Role of Mineral Composition, Flow Rate, and Fracture Aperture Heterogeneity

Alteration and Erosion of Rock Matrix Bordering a Carbonate-Rich Shale Fracture

Modeling Reactive Transport Processes in Fractures

Modeling of Solute Transport in a Fracture-Matrix System with a Three-Dimensional Discrete Fracture Network

Multiphase Reactive Transport Modeling – the Impacts of Two-Phase Flow on Mineral Reaction Rate

Analytical solution of coupled stress-flow-transport processes in a single rock fracture

Semi-analytical Models of Mineral Dissolution in Rough Fractures with Permeable Walls

The Impacts of Micro‐Porosity and Mineralogical Texture on Fractured Rock Alteration

Reactive Transport Modeling in Porous Fractured Media: Application to Weathering Processes

Modeling and Experimental Investigation of the Evolution of Altered Zones at the Shale-Fluid Interface

Analyzing the Dynamics of Mineral Dissolution during Acid Fracturing by Pore-Scale Modeling of Acid-Rock Interaction

Modelling of hydro-mechanical coupling and transport in densely fractured rock mass

A discrete fracture matrix framework for simulating single-phase flow and non-isothermal reactive transport

Non-equilibrium solute transport in a fractured rock matrix system under a radial flow pattern