Abstract:Inductively coupled plasma generator is one of the core components of the near-space high-speed target plasma electromagnetic scientific experimental research device, which is often used to simulate high enthalpy and high speed plasma sheath environment. In order to study the discharge characteristics of inductively coupled plasma generator under high power, radio frequency and medium pressure, the numerical simulation and experiment are combined to study its internal heat transfer and flow characteristics in this paper. Based on the local thermodynamic equilibrium conditions, the numerical simulation of large-scale radio frequency and medium pressure inductively coupled plasma with a power of 100–400 kW is carried out through the multi-field coupling of flow, electromagnetic and temperature field, and verified by light intensity and spectrum experiment. The results show that the electromagnetic field distribution in the high-power thermal balance inductively coupled plasma generator is similar to that of the small- and medium-sized power plasma generator. The discharge energy dissipation occurs mainly in the area where the induction coil is located. The temperature of the inner wall of the quartz tube is higher at the coil location than in other areas, and the plasma has a ring-shaped high-temperature structure. The outer wall of the quartz tube is set to be the boundary condition of heat flux for simulating the temperature change of the quartz tube under cold blowing. This setting is in coincidence with factual situations. The wall temperature of the quartz tube at the entrance and at the induction coil section are found to be relatively high. When the large-size inductively coupled plasma generator works, an obvious return vortex is generated at the entrance due to the temperature difference and the electromagnetic pumping effect, and the exit velocity increases slightly with the increase of power. At the same time, the discharge experiment under the corresponding conditions shows that there is found a ring structure with bright edges and dark centers in the axial image of the argon discharge. Moreover, the emission spectrum of argon plasma is measured through the spectrum diagnosis system and the spatial distribution of the generator electron temperature is obtained. The light intensity of the discharge image and the electron temperature measured by the spectrum are found to be in comparative coincidence with the COMSOL simulation temperature result, demonstrating the validity of the numerical simulation results under thermodynamic equilibrium conditions. The numerical simulation results in this paper are also applicable to the optimization design and temperature resistance evaluation of the inductively coupled plasma generator.

Fundamental Experiment and Numerical Simulation of Ne/Xe Plasma Magnetohydrodynamic Electrical Power Generation

Numerical study of plasma behavior in a disk‐shaped noble gas MHD generator

Hydrogen Utilization as a Plasma Source for Magnetohydrodynamic Direct Power Extraction (MHD-DPE)

Analysis of Enthalpy and Energy Conversion Efficiency in High-Power Inductively Coupled Plasma

Numerical Simulation and Experimental Study of High-Power Thermal Equilibrium Inductively Coupled Plasma

Numerical Simulation and Experimental Research on an Inductively Coupled RF Plasma Cathode

Generation of low-energy abundant electron energy probability functions using a magnetized plasma source

Modeling of heating scheme impacts on neon seeded plasmas with the resonant magnetic perturbation application in the large helical device: ECR and NBI heating

Full particle-in-cell simulation of the interaction between two plasmas for laboratory experiments on the generation of magnetized collisionless shocks with high-power lasers

Detailed and simplified plasma models in combined-cycle magnetohydrodynamic power systems

A Non-Equilibrium Plasma Generator

Study of seed plasma generation for NBI plasma start-up using non-resonant microwave launch in Heliotron J

Simulating a pulsed power-driven plasma with ideal MHD

Primary Study on Production of Kev Level Characteristic X-radiation Via High Power Z-pinch on Qiangguang-I Generator

Magnetohydrodynamic Numerical Study in a Supersonic Plasma Torch

Magnetohydrodynamic Modeling and Simulation of a Vacuum Arc Plasma Jet with a Ring Anode under Different External Magnetic Fields

A Simplified 2-D Fluid Model Of Plasma Formation Under Pulsed High Power Microwaves In Atmospheric Gases

Numerical simulation of magnetic field influence on plasma and electron extraction of electron cyclotron resonance neutralizer

First experiments on RF plasma production at relatively low magnetic fields in the LHD

Thermodynamic Parameters and Energy Transfer Analysis of High Enthalpy Inductively Coupled Plasma

Simulation of self-generated magnetic fields in an inertial fusion hohlraum environment