Abstract:Load transformation from the yielding part of the soil to the adjacent part is known as the soil arching effect, which plays an important role in the design of various geotechnical infrastructures. Terzaghi's trapdoor test was an important milestone in the development of theories on soil arching. The research on earth pressure of the trapdoor problem is presented in this paper using the three-dimensional (3D) discrete element method (DEM). Five 3D trapdoor models with different heights are established by 3D DEM software PFC 3D. The variation of earth pressure on the trapdoor with the downward movement of the trapdoor, the distribution of vertical earth pressure along the horizontal direction, the distribution of vertical earth pressure along the vertical direction, the distribution of lateral earth pressure coefficient along the depth direction, the magnitude and direction of contact force chain are studied, respectively. Related research results show that the earth pressure on the trapdoor decreases rapidly after the downward movement of the trapdoor, and then reaches the minimum earth pressure. After that, the earth's pressure will rise slightly, and whether this phenomenon occurs depends on the depth ratio. For the bottom soil, due to the stress transfer caused by the soil arching effect, the ratio of earth pressure in the loose area decreases, while the ratio of earth pressure in the stable area increases. With the trapdoor moving down, the vertical earth pressure along the depth in the stable zone is basically consistent with the initial state, which shows an approximate linear distribution. After the trapdoor moves down, the distribution of earth pressure along with the depth in the loose area changes, which is far less than the theoretical value of vertical earth pressure of its self-weight. Because of the compression of the soil on both sides, the lateral earth pressure coefficient of most areas on the central axis of the loose zone is close to the passive earth pressure coefficient K-p. The existence of a 'soil arch' can be observed intuitively from the distribution diagram of the contact force chain in the loose zone.

Arching Development in Transparent Soil during Multiple Trapdoor Movement and Surface Footing Loading

Dynamic Behaviors of Piled Embankment Under High-Speed Train Loads

Degradation Mechanisms of Soil Arching under a Localized Cyclic Surface Loading

Progressive Failure Mechanism in Granular Materials Subjected to an Alternant Active and Passive Trapdoor

Experimental Study of Soil Arching Effect under Seepage Condition

Experimental and Theoretical Investigations on Evolution of Soil-Arching Effect in 2D Trapdoor Problem

Effect of arch foot settlement on soil arching in pile-supported embankments under localized surface loading: Numerical damping spring-based trapdoor tests

Investigating Soil Arching Evolution in Dense Sand Via Fully-Instrumented Trapdoor Tests

Experimental Investigation of the Evolution of Suffusion in Gap-Graded Arched Soils at Different Soil Arching Ratios

Three-Dimensional Theoretical Model for Soil Arching with Inclined Slip Surfaces

Earth Pressure of the Trapdoor Problem Using Three-Dimensional Discrete Element Method

Passive Soil Arching Effect in Aeolian Sand Backfills for Grillage Foundation

Soil movement mechanism associated with arching effect in a multi-strutted excavation in soft clay

Arching development above active trapdoor: insight from multi-scale analysis using FEM–SPH

Soil arching evolution in GRPS embankments: Numerical spring‐based trapdoor tests

Mechanism and development law of soil arch effect behind anti-slide piles

Effect of non-simultaneous movement of adjacent twin-trapdoor on soil arching effect through discrete-element method simulation

Degradation of Soil Arching Caused by Suffusion in Gap-Graded Soils

Micro mechanism and analytical model of stress distribution in loosened soil zone above active trapdoor

An Analytical Method for Predicting Load Acting on Geosynthetic Overlying Voids

Investigation of Suffusion in Soil with Arching Based on CFD–DEM Simulation