Abstract:Power transformers represent an important part of the capital investment in transmission and distribution substations. The cooling of the windings (electrical coil) depends on the convection of heat, enhanced by the forced circulation of oil through the windings and heat exchangers. The forced circulation of oil combined with the forced circulation of air in the heat exchangers is usually found in mobile transformers, whose compact structure is a challenge in terms of heat transfer rates. An improper design or fabrication problem associated with the assembling of the cooling system may result in an inefficient exchange of heat, which may lead to transformer failure from overheating or a reduction of the life span. In this context, the present work proposes a 2D mathematical model to simulate the winding cooling system of a 138 × 69–34 × 13.8 kV 25 MVA Mobile Power Transformer with the objective of investigating the causes of overheating. The model is implemented in CFD Ansys-Fluent® version 17.0 and validated with experimental data. It is evaluated the velocity and temperature distribution, and the identification of the hot spots on the transformer operating considering the nominal conditions for oil flow rate, inlet temperature, and power dissipated. The hot spot temperatures are compared with the current Brazilian Association of Technical Standards—NBR 5356-2: 2007 Power Transformers Part 2: Heating. After, some geometric and/or operational constraints are artificially imposed on the transformer. Their impact on the velocity and temperature fields, as well as the hot spot temperatures, are mapped in order to verify if they still respect the standard ́s temperature limits and if imposed constraints may lead to the transformer failure. The numerical results clearly illustrate that geometric imperfections in the disks, guides, or axial cooling ducts have a direct impact on oil flow and temperature distributions. These imperfections can also alter the positioning and significantly increase the temperature of the hottest spot within the winding, sometimes even exceeding the requirements of the ABNT NBR 5356:2 standard in certain scenarios. Therefore, the proposed mathematical model serves as a valuable tool for investigating a complex and common issue within the energy distribution system. This issue not only inconveniences the population but also leads to economic challenges each year. Finally, the outcomes of this study can provide engineers with essential insights to enhance the thermal design of power transformers, as well it can assist in guiding maintenance efforts and understanding the root causes of new failures.

Lifespan and efficiency gain for outdoor electronic systems from radiative cooling: A case study on distribution transformers

Energy savings of radiative cooling paints applied to residential buildings

A study on the optimization of cooling performance for oil-immersed transformers in high temperature environments utilizing response surface methodology

Design of radiative cooling paint coating and insights into its sub-ambient cooling behaviour

Enhancing heat transfer in power transformer radiators via thermo-fluid dynamic analysis with periodic thermal boundary conditions

Evaluation of Cooling Solutions for Outdoor Electronics

Study on the cooling energy saving potential of a novel radiative cooling paints in building application

Full Daytime Sub-ambient Radiative Cooling with High Figure of Merit in Commercial-like Paints

An experimental determination of the optimum cooling model for dry-type transformers for different cooling configurations

Low-cost waterborne radiative cooling paint for large scale production and application in buildings

Hybrid Passive Cooling for Power Equipment Enabled by Metal-Organic Framework

Cooling Performance of Porous Polymer Radiative Coating under Different Environmental Conditions Throughout All-Year

Experimental and Numerical Investigation on Energy-Saving Performance of Radiative Cooling Coating for Metal Container Office

Improved Abrasion-Resistant Coatings Using Designed Inorganic Particles for Durable Radiative Cooling

Experimental and Numerical Investigation on Thermal Management of an Outdoor Battery Cabinet

Radiative cooling for buildings: A review of techno-enviro-economics and life-cycle assessment methods

Thin paints for durable and scalable radiative cooling

A novel aqueous scalable eco-friendly paint for passive daytime radiative cooling in sub-tropical climates

Cooling Transformer in Electricity Delivery Via Liquid Metal and Its Feasibility Evaluation

Optimally Designed Multimaterial Microparticle–Polymer Composite Paints for Passive Daytime Radiative Cooling

Numerical evaluation of the directed oil cooling system of a mobile power transformer