Wire-cut electrical discharge machining of duplex stainless steel: a study

S. Ragu Nathan,G. Manikanta,Tushar Sonar,M. Baburaj

DOI: https://doi.org/10.1080/10426914.2024.2362617

IF: 4.7832

2024-06-05

Materials and Manufacturing Processes

Abstract:In this study, the duplex stainless steel is machined using a wire-cut electrical discharge machining process to overcome the issues of poor finishing, lower dimensional accuracy, and rapid wear of cutting tools in conventional machining processes. The higher rate of material removal and superior finish on the machine surface is dependent on kerf loss, which is expressed as the mean kerf width assessed at certain locations. Nevertheless, this approach is typically not effective in explicating the intricacies of true kerf loss due to the random selection of distinctive points. This work proposes an area-based measuring approach to quantify the kerf loss by taking into account any imperfections on the kerf wall. At the pulse on time of 20 μs and current of 3 A, the machining appears not stable. The pulse on time, current, and voltage of 12 μs, 1 A, and 80 V proved suitable for obtaining excellent dimensional precision.

materials science, multidisciplinary,engineering, manufacturing