Abstract:<p>Standard test condition (STC) is widely used to measure the efficiency of solar photovoltaic modules. But, the specified values of different factors of this standard are rarely found in the actual field. Some of the crucial factors of the said standard are module temperature, angle of incidence (AOI), amount of incident solar radiation, and type of spectrum. This research paper presents the energy generation of a photovoltaic module integrated double pane window system under the effect of the above factors. The type of the considered photovoltaic module is thin-film semi-transparent made of Cadmium Telluride (CdTe). For the calculation, the material characteristics were initially processed using different software. The validity of the simulated values was checked with experimental findings. In the study, except the incident spectrum, all other factors found to affect the output negatively. For example, because of higher operating cell temperature, the decreases in energy generation ranges between 2.9% and 6.3% among the months in the year. Further, with the influence of the investigated factors, the considered STPV system is found to generate maximum energy of 95.3 kWh/m<sup>2</sup> per annum. This energy generation is 10.5% less than the energy calculated using the conversion efficiency found at STC. One of the outcomes of this analysis is the incorporation of the combined effects of four critical factors in the energy generation of photovoltaic systems. The results and the method of this work provide a useful reference to the scientific community for the development of an improved testing procedure of solar photovoltaic modules.</p>

Experimental investigation on thermal characteristics and output performance of PV panel under linear light source and windy conditions

Hotspots and Performance Evaluation of Crystalline-Silicon and Thin-Film Photovoltaic Modules

Investigation of wind speed cooling effect on PV panels in windy locations

Performance of photovoltaic panels with different inclinations under uniform thermal loading

Evaluation of Photovoltaic Panel Temperature in Realistic Scenarios

An experimental and numerical study of wind effects on a ground-mounted solar panel at different panel tilt angles and wind directions

Analysis of dust deposition law at the micro level and its impact on the annual performance of photovoltaic modules

Characterization of PV Modules under Actual Operating Conditions

Parametric study on thermodynamic performance of a novel PV panel and thermal hybrid solar system

Analysis of the influencing factors of the dust on the surface of photovoltaic panels and its weakening law to solar radiation — A case study of Tianjin

Photovoltaic Output Parameters Of A Mono-Crystalline Silicon Solar Cell With Non-Uniform Horizontal Temperature Distributions

Experimental study of the effect of ambient temperature on the output characteristics of PV-PCM systems

Performance evaluation of a solar photovoltaic system

Energy performance of window integrated photovoltaic system in actual operating condition

Numerical simulation study on the impact of wind-blown sand action on the loading of photovoltaic systems

Comparative study on heat transfer characteristics of molten PCM in PV/PCM air-based system based on grey relation analyses

Performance Characteristics of GaInP/InGaAs/Ge Triple-Junction Photovoltaic Panels for Near-Space Vehicles Via Ground Experiments

Performance Analysis of a Grid-connected High Concentrating Photovoltaic System under Practical Operation Conditions

Experimental and numerical study on performance enhancement of photovoltaic panel by controlling temperature with phase change material

Experimental and Numerical Comparative Investigation on a Concentrating Photovoltaic System

Coupled Electrical-Thermal Modelling of Photovoltaic Modules under Dynamic Conditions