Abstract:Space debris has become a critical issue, with debris in orbit surpassing active satellites, posing significant risks to space sustainability. Payloads or rocket bodies discarded post-mission in LEO without orbital control are major sources. The IADC guidelines recommend limiting post-mission presence in protected regions to 25 years. The FCC recently introduced stricter regulations, reducing the allowable post-mission stay for LEO satellites to 5 years. These changes necessitate integrating deorbiting systems into satellite designs. However, adding extra fuel and engines for active deorbiting presents challenges due to LEO satellites' mass and volume limitations, especially for large constellations or CubeSats. This often leads to prioritizing mission-critical components over deorbiting systems. Thus, alternative approaches like passive deorbiting techniques or international regulations are explored. Drag sails are a cost-effective passive solution for small and medium-sized LEO satellites. This paper proposes a plug-and-play drag sail module using COTS components for CubeSats and sub-mass satellites. The scalable design is derived from mission requirements and trajectory analysis. The technique includes active control for quicker deorbiting at specific orbital LTAN. Inspired by JAXA's IKAROS mission, the deployment mechanism uses residual angular momentum and follows a standard sequence. A cost analysis estimates the system's breakeven point. A prototype with a 3D-printed deployment system and inverted stepper motor was tested and compared to a numerical model. A tension model for sail extension petals was developed using curve fitting from test data. SIMULINK multibody models are available for simulations. Further experimentation and prototype development are required to assess real-world performance, with a control system identified as crucial.

Differential Drag Control Scheme for Large Constellation of Planet Satellites and On-Orbit Results

Nonlinear Programming Control Using Differential Aerodynamic Drag for CubeSat Formation Flying

Relative roll control of satellite docking using electromagnetic coils

Propulsion-Free Cross-Track Control of a LEO Small-Satellite Constellation with Differential Drag

Optimized Relative Phase Maintenance for Heterogeneous Area-to-mass Ratio Microsatellite Constellations

A planning tool for optimal three-dimensional formation flight maneuvers of satellites in VLEO using aerodynamic lift and drag via yaw angle deviations

Satellite design optimization for differential lift and drag applications

Linearized model for satellite station-keeping and tandem formations under the effects of atmospheric drag

Relative Position and Attitude Control for Drag-Free Satellite with Prescribed Performance and Actuator Saturation

Analysis of Initial Deployment Strategy for Low-Orbit Large-Scale Constellations

Satellite Formation Flying Control by Using Only Angle Measurements

Simultaneously Adjusting Deployment Strategies for Mega-Constellations Using Low-Thrust Maneuvers

Lyapunov-Based Control via Atmospheric Drag for Tetrahedral Satellite Formation

An optimal deployment strategy for multi-plane satellite constellation using a generalized non-planar maneuver

Rotational and Translational Integrated Control for Inner-formation Gravity Measurement Satellite System

Plug-and-Play Drag Sail Module for LEO Satellites: Implementation and Early Testing of AirDragMod (ADM)

Relative Orbit Control Algorithms and Scenarios for the Inertial Alignment Hold Demonstration Mission by CubeSat Formation Flying

Distributed adaptive prescribed-time orbit containment control for satellite cluster flight

Reconfiguration of a satellite constellation in circular formation orbit with decentralized model predictive control

Orbital Tolerance and Intrinsic Orbital Capacity for Electric Propulsion Constellations

Passivity-Based Distributed Acquisition and Station-Keeping Control of a Satellite Constellation in Areostationary Orbit