Investigation of structural, physical and radiation attenuation properties of lithium tetra-borate with Cr2O3 glass-ceramics: experimental and theoretical methods

Neslihan Ekinci,Esra Kavaz,Norah A. M. Alsaif,Y. S. Rammah,Sevda Sarıtaş,Bunyamin Aygün
DOI: https://doi.org/10.1007/s41779-024-01094-8
2024-10-01
Journal of the Australian Ceramic Society
Abstract:Different amounts of Cr 2 O 3 were added to the mixture of 70Li 2 B 4 O 7 + xCr 2 O 3 +(25-x)Li 2 O + 4NiO + 0.75MnO 2 + 0.25Na 2 O (x = 4, 8, 12, 16, and 20 wt%) to create new glass-ceramics samples with varying densities. Structural and physical, and γ-ray attenuation properties of the prepared samples have been investigated. To this end, the EpiXS software and EDXRF spectrometer, which is equipped with an Ultra Ge detector and a 133Ba (3 Ci) radioisotope source were employed. The relative differences between the theoretical and experimental results were in the range of 0.009 and 0.048. With XRD spectrometry, a material may be identified or its atomic-level structure could be discovered. In XRD investigations, the Cr1 structure which has the maximum quantity of Li 2 O and the lowest amount of Cr 2 O 3 exhibits large crystal particle sizes. The crystal particle size of the Cr2 structure is nonetheless greater than that of the Cr1 structure. The shift in the ratio of Li 2 O to Cr 2 O 3 caused a change in the size of the crystal particles inside the structure. The highest mass-attenuation coefficient (MAC) was found in the highly dense Cr5 sample compared to the other samples. A similar trend appears in the linear-attenuation coefficient (LAC). The half-value layer (HVL) arranged as follows at all energies: (HVL) Cr1 > (HVL) Cr2 > (HVL) Cr3 > (HVL) Cr4 > (HVL) Cr5 . The mean free path (MFP) showed a similar pattern of HVL. Results revealed that suggested materials can be protecting against radiation.
materials science, ceramics
What problem does this paper attempt to address?