Passing-through I-plates-to-SHS moment resisting joints subjected to symmetric bending moments

Mouad Madhouni,Maël Couchaux,Mohammed Hjiaj,Alper Kanyilmaz

DOI: https://doi.org/10.1016/j.tws.2024.112442

IF: 5.881

2024-09-15

Thin-Walled Structures

Abstract:When using hollow structural section (HSS) members in multi-storey buildings, beam-to-column moment resisting connections' design raises critical questions to tackle. With conventional welded and bolted joints' response being generally very flexible, the design resistance becomes governed by a deformation criterion rather than a strength criterion. This underscores the necessity for smart reinforcement techniques. A widespread solution is the diaphragm approach, in which the stiffeners usually protrude over the tubular column. The solution of plates passing through the HSS column is another stiffening option which was studied recently for CHS, yet, SHS columns have not been subject to comparable scrutiny. The objective of this paper is to study experimentally, numerically, and analytically the mechanical behaviour of I-beam-to-SHS column moment resisting joints using passing through I-plates under symmetric bending moments. The testing of two full-scale specimens corroborates previous findings with CHS columns in the elastic regime. However, significant deviations were observed in the post-peak response, revealing new insights into the behaviour of SHS columns. Failure was due to progressive buckling of passing through plates and yielding of tube-wall in transverse compression. A finite element model using solid and contact elements is developed and validated against experimental data. This model underscores how loads are redistributed between the tube wall and passing plates. A simplified version of the FE model is used to perform a thorough parametric numerical analysis on 101 configurations expanding upon the experimental test database by varying geometrical parameters such as passing plate thickness, tube, and beam dimensions. Finally, an analytical model integrating the different components of the joint is proposed to evaluate the initial rotational stiffness and the bending resistance.

engineering, mechanical,mechanics, civil