Abstract:The increasing complexity of low-voltage networks poses a growing challenge for the reliable and fail-safe operation of electricity grids. The reasons for this include an increasingly decentralized energy generation (photovoltaic systems, wind power, etc.) and the emergence of new types of consumers (e-mobility, domestic electricity storage, etc.). At the same time, the low-voltage grid is largely unmonitored and local power failures are sometimes hard to detect. To overcome this, power line communication (PLC) has emerged as a potential solution for reliable monitoring of the low-voltage grid. In addition to establishing a communication infrastructure, PLC also offers the possibility of evaluating the cables themselves, as well as the connection quality between individual cable distributors based on their Signal-to-Noise Ratio (SNR). The roll-out of a large-scale PLC infrastructure therefore not only ensures communication, but also introduces a tool for monitoring the entire network. To evaluate the potential of this data, we installed 38 PLC modems in three different areas of a German city with a population of about 150,000 as part of the F\"uhler-im-Netz project. Over a period of 22 months, an SNR spectrum of each connection between adjacent PLC modems was generated every quarter of an hour. % and the voltage was measured every minute. The availability of this real-world PLC data opens up new possibilities to react to the increasingly complex challenges in future smart grids. This paper provides a detailed analysis of the data generation and describes how the data was collected during normal operation of the electricity grid. In addition, we present common anomalies, effects, and trends that could be observed in the PLC data at daily, weekly, or seasonal levels. Finally, we discuss potential use cases and the remote inspection of a cable section is highlighted as an example.

Poster Abstract: Bits and Watts: Improving energy disaggregation performance using power line communication modems

A Survey of the Research on Non-intrusive Load Monitoring and Disaggregation

A Power Optimised Narrowband Power-Line Communication System

A Comprehensive Review on the NILM Algorithms for Energy Disaggregation

Residential Electricity Consumption Behavior Analysis and Energy Management Based on NILM

A secure edge monitoring approach to unsupervised energy disaggregation using mean shift algorithm in residential buildings

Non-Intrusive Load Monitoring for Residential Appliances with Ultra-Sparse Sample and Real-Time Computation

A Deep Learning Technique using Low Sampling rate for residential Non Intrusive Load Monitoring

A Field Study of Nonintrusive Load Monitoring Devices and Implications for Load Disaggregation

Hybrid Powerline/Wireless Diversity for Smart Grid Communications: Design Challenges and Real-time Implementation

CALM: Contactless Accurate Load Monitoring Via Modality Distillation.

Smart Edge Device Utilizing Power Line Communication for Energy Management and Control of Electrical Appliances

Complexity of Power Draws for Load Disaggregation

Nonintrusive Load Monitoring Algorithm Using Mixed-Integer Linear Programming

NILMTK: An Open Source Toolkit for Non-intrusive Load Monitoring

Autonomous Load Disaggregation Approach based on Active Power Measurements

Towards Designing PLC Networks for Ubiquitous Connectivity in Enterprises

A Scalable Real-Time Non-Intrusive Load Monitoring System for the Estimation of Household Appliance Power Consumption

An in depth study into using EMI signatures for appliance identification

Mixed-Integer Nonlinear Programming for State-based Non-Intrusive Load Monitoring

FiN: A Smart Grid and Power Line Communication Dataset