Abstract:International Journal of Aeroacoustics, Ahead of Print. Based on the conventional beamforming (CBF), some algorithms for far-field sound source identification have been proposed in the past few decades. Typically, the functional beamforming (FBF) and the deconvolution methods, such as CLEAN, CLEAN with source coherence (CLEAN-SC), CLEAN-SC with compressed grids (CLEAN-SC-CG), CLEAN with cross spectral matrix function (CLEAN-CSM), High-resolution CLEAN-SC (HR-CLEAN-SC), are frequently mentioned and their advantages are widely discussed in the previous literatures. To assess their efficacy and suitability in engineering applications, with a focus on spatial resolution, computational efficiency, and dynamic range, a comparative study by locating two types of sound sources is carried out. The first scenario represents the case where the distance between two sound sources is smaller than the Rayleigh limit, while the second scenario represents the situation involving multiple sound sources, such as four or more complex sound sources. The analysis demonstrates that CBF, CLEAN, and CLEAN-SC cannot surpass the Rayleigh limit. However, FBF, CLEAN-SC-CG, CLEAN-CSM, and HR-CLEAN-SC have the potential to overcome it. In FBF, the grid mismatch results in a compromise between its dynamic range and source strength estimation. Meanwhile, HR-CLEAN-SC requires prior knowledge of the number of sound sources, which is challenging in applications. Because of superiority in the fundamental acoustic image and searching strategy, CLEAN-CSM and CLEAN-SC-CG exhibits superior features compared to the others. By compressing the number of grids, the CLEAN-SC-CG can improve the computational efficiency up to at least 46%. By constructing the cross spectral matrix function related to the real source, CLEAN-CSM uses the power function to simultaneously enhance the spatial resolution, dynamic range and source strength estimation. The conclusions are further validated through sound-source identification experiments involving two loudspeakers and an engine. The findings presented in this paper serve to guide the selection of suitable approaches for multi-sound source identification in engineering applications.

Clear Imaging Beamforming Method for the Noise Source Identification in Car Cabin

A Method of Sound Field Control Using Beam Deflection

Simulation and Experimental Demonstration of Sound Field Control Using Beam Deflection

Filter-and-sum based high-resolution CLEAN-SC with spherical microphone arrays

A novel approach for accurate identification of complex noise sources

Noise Sources Measurement and Identification for Moving Automobiles

Comparison and application of the far-field identification algorithms for multiple sound sources based on microphone array

Acoustic Beamforming via Interference-Plus-Noise Covariance Matrix Construction for Interferences and Noise Attenuation.

A High-Resolution and Low-Frequency Acoustic Beamforming Based on Bayesian Inference and Non-Synchronous Measurements

Identification of dominant interior noise sources in micro commercial vehicle based on sound quality analyzing

Study on active noise control inside automobile cabin

Application of measurement technology of sound intensity in noise source identification of automotive interior noise

Design of a Loudspeaker Array for Personal Audio in a Car Cabin

Identification of Sound Source Based on Microphone Array

A Study on Multi-Channel Active Sound Profiling Algorithm for Hybrid Control of Broadband and Narrowband Noise Inside Vehicles

Active control of interior road noise using the remote microphone technique

Identification of noise sources radiation based on 3D transfer path acoustics holography

Beamforming and other methods for denoising microphone array data

Beamforming And Compressive Sensing Mode Detection Of Duct Acoustic Source By Sensor Array

Sound Focusing Based On Optimal Loudspeaker Array Beamforming

Achieving 3D Beamforming by Non-Synchronous Microphone Array Measurements