Abstract:Due to the energy crisis and environmental pollution, the installed capacity of inverter-based resources (IBRs) in power grids is rapidly increasing, and grid-following control (GFL) is the most prevalent at present. Meanwhile, grid-forming control-based (GFM) devices have been installed in the grid to provide active support for frequency and voltage. In the future GFL devices combined with GFM will be promising, especially in power systems with high penetration or 100% IBRs. When a short-circuit fault occurs in the grid, the controlled current source characteristic of the GFL devices leads to insufficient dynamic voltage support (DVS), while the GFM devices usually reduce the internal voltage to limit the current. Thus, deep voltage sags and undesired disconnections of IBRs may occur. Moreover, due to the dispersed locations and the control strategies' diversity of IBRs, the voltage support of different devices may not be fully coordinated, which is not conducive to short-term voltage security (STVS). To address this issue, a control scheme based on the simulation of transient characteristics of synchronous machines (SMs) is proposed. Then, a new fault ride-through strategy (FRT) is proposed based on the characteristic differences between GFL and GFM devices, and an optimization model of multi-device control parameters is formulated to meet the short-term voltage security constraints (SVSCs) and device capacity constraints. Finally, a fast solution method based on analytical modeling is proposed for the model. Test results based on the doublegenerator-one-load system, the IEEE 14-bus system, and other systems of different sizes show that the proposed method can effectively enhance the active support capability of GFL and GFM to the grid voltage, and avoid the large-scale disconnection of IBRs

Power Supporting Control of Grid-forming Converters under Grid Voltage Sags for Transient Stability Enhancement and Overcurrent Limitation

Transient Voltage Stability Analysis and Enhancement of Grid-Following Converters Considering Current Limitation

Current Saturation Analysis and Anti-Windup Control Design of Grid-Forming Voltage Source Converter

Control Method for Fault Ride-through of DFIG-based Wind Turbines Applied to Weak Grids

A Transient Stability-Enhanced Method for Grid-Forming VSCs Considering the Current Limiting Algorithm

A Novel Method for Voltage Support Control under Unbalanced Grid Faults and Grid Harmonic Voltage Disturbances

An Adaptive Current-Limiting Strategy for Grid-Forming Converters under Grid Faults

Analysis and Benchmarking of Grid-Forming Control for Power Converters

Active Power and Voltage Cooperative Control for Improving Fault Ride-Through Capability of Grid-Forming Converters

A Novel Fault Ride Through Strategy for Grid-Connected Virtual Synchronous Generators: Power Angle Stability Enhancement and Current Limiting

Control of Grid-Forming VSCs: A Perspective of Adaptive Fast/Slow Internal Voltage Source

Modeling and Control Technology of Grid Side Converter under Transient Harmonic Disturbance

A combined regulation method of transient power angle stability control and fault current suppression for VSG

An Improved Current-Limiting Control Strategy of Grid-Forming Inverter During Grid Fault

Overvoltage ride through control strategy for improving voltage support capability of virtual synchronous generator

Transient stability improvement of grid-forming voltage source converters considering current limitation

Transient stability enhancement control strategy for droop-controlled voltage source converter

Dynamic Current Limiting of Grid-forming Converters for Transient Synchronization Stability Enhancement

Virtual Flux and Positive-Sequence Power Based Control of Grid-Interfaced Converters Against Unbalanced and Distorted Grid Conditions

Configuration Method of Grid-Forming Converters to Enhance Multi-converter System Stability

Active Support of Inverters for Improving Short-Term Voltage Security in 100% IBRsPenetrated Power Systems