Abstract:In order to construct a low-impedance loop for common-mode electromagnetic interference (EMI) signals, traditional method is to use Y-capacitors as filtering components. However, in the commonly used isolated ac-dc switching-mode power supplies (SMPS), the Y-capacitors branch also behaves as a terrible leakage current loop. For the safety of human beings, this leakage current is not allowed in commercial used equipment, such as chargers, medical instruments, etc. Therefore, certain works should be done to both acquire good EMI performance and satisfy the strict leakage current limitation. The goal of this paper is try to meet these two demands at the same time. In this paper, a novel non-Y-capacitor EMI design concept for SMPS is proposed for the first time. By getting rid of traditional EMI filtering component-the Y-capacitors, the leakage current can be eliminated entirely. Meanwhile, to face with EMI design challenge, optimized transformer architecture is presented. Analysis of the transformer architecture as well as the auxiliary winding has been carried out. Then, a novel topology suitable for non-Y-capacitors converter is proposed and the design procedure of the proposed topology is discussed in detail. The proposed concept is applied to several popular converter topologies. The experiment results demonstrated the effectiveness and feasibility of the proposed non-Y-capacitor design schemes.

A Pulse-Width-modulation-based Approach to Eliminate Inrush Currents of Switch-Mode Power Supply

A General Pulse Width Modulation Method for Zero-Voltage-Switching Active-clamping Three-phase Power Converters: Edge Aligned Pulse Width Modulation (EA-PWM)

Pulse-width modulation scheme for a ZVS single-phase inverter in rectifier operation

Review on Pulse-Width Modulation Strategies for Common-Mode Voltage Reduction in Three-Phase Voltage-Source Inverters

A Slow Given Method to Suppress the Start-Up Inrush Current of PWM Rectifier

A Technique on Driving-pulse Edge-modulation and Its Application in Reducing the Switching Voltage Spike of Power Electronic Device

A High-Performance PWM Controller with Adjustable Current Limit

Pulse-Cycle Skip Modulation in Switching Converter

Seamless Mode-Switch Control Scheme for Primary Side Regulation Flyback with Capacitorless Self-Adaptive Startup

A Step-Variable Soft Start Control Method Applied to Boost Type PFC Rectifier

PWM control to reduce surge current of DC-bus capacitor for hybrid-clamped multilevel inverter

Transformer-Less Soft-Switching High-Gain PWM Boost Converter With Reduced Components and Increased Effective Duty Cycle

A study of startup inrush current of three-phase voltage source PWM rectifier with PI controller

An Improved PWM Control Method to Reduce Surge Current Through Capacitors in Hybrid-Clamped Multilevel Inverter

A Switching Strategy of Dead-Time Elimination for Pulse Width Modulation Converters

A Closed-Loop Soft Startup Strategy to Suppress Inrush Current for Full-Bridge Modular Multilevel Converters

A Dc Link Switch-Based Common Mode Voltage Reduction Scheme in Pwm Inverter Drives

Application of Pulse Skip Modulation to Charge Pump Circuits

Conducted EMI Mitigation Schemes in Isolated Switching-Mode Power Supply Without the Need of a Y-Capacitor

DC-Link Capacitors RMS Current Reduction PWM Method Based High Frequency SiC Three-Phase Inverter

An Investigation into Characteristics of Switching Power Supply with PSM