Abstract:The proton exchange membrane fuel cell (PEMFC), with a high energy conversion efficiency, has become an important means of hydrogen energy utilization. However, water condensation is unavoidable in the PEMFC because of low operating temperatures. The impact of liquid water on PEMFC performance and stability is significant. The gas diffusion layer (GDL) provides a critical transport path for liquid water in the PEMFC. Liquid water saturation and distribution in the GDL determine water flooding and mass transfer efficiency in the PEMFC. In this study, focusing on the effects of the water introduction method, osmotic pressure, and contact angle, the liquid water transport in the GDL was numerically investigated based on a pore-scale model using the volume of fluid (VOF) method. The results showed that compared with the conventional water introduction method without cracks, the saturation and spatial distribution of water inside the GDL obtained in the simulation were more consistent with the experimental results when the water was introduced through the microporous layer (MPL) crack. It was found that increasing the osmotic pressure resulted in a faster rate of water penetration, faster approaching the steady-state performance, and higher saturation. The ultra-high osmotic pressure contributed to the secondary breakthrough with a significant increase in saturation. Increasing the contact angle caused higher capillary resistance, especially in the region with small pore sizes. At a constant osmotic pressure, as the contact angle increased, the liquid water gradually failed to penetrate into the small pores around the transport path, causing saturation reduction and an ultimate failure to break through the GDL. Increasing the contact angle contributed to a higher breakthrough pressure and secondary breakthrough pressure.

A New Insight into the Relationship of Interface Phase Between Aqueous Phase and Solid Phase on Gas Permeability below Glass Transition Temperature

Numerical Modeling of Liquid Water Transport Inside and Across Membrane in PEM Fuel Cells

Effects of Membrane Electrode Assembly Properties on Two-Phase Transport and Performance in Proton Exchange Membrane Electrolyzer Cells

Modeling of Two-Phase Transport in Proton Exchange Membrane Electrolyzer Cells for Hydrogen Energy

Gel-state Polybenzimidazole Proton Exchange Membranes with Flexible Alkyl Sulfonic Acid Side Chains for a Wider Operating Temperature Range (25–240 °C)

Interfacial Water Management of Gradient Microporous Layer for Self-Humidifying Proton Exchange Membrane Fuel Cells

Structural Design of Gas Diffusion Layer for Proton Exchange Membrane Fuel Cell at Varying Humidification

Effect of Three-Dimensional Geometric Structure and Surface Wettability on Two-Phase Flow Behavior in a Proton Exchange Membrane Fuel Cell Gas Flow Channel: Modeling and Simulation

Experimental and Model Refinement of Water Content and Membrane Conductivity in Reinforced Composite Proton Exchange Membranes

Influence of wettability on liquid water transport in gas diffusion layer of proton exchange membrane fuel cells (PEMFC)

Microscopic Insight into Phase Separation of Poly (arylene Piperidine)s-Based High-Temperature Proton Exchange Membrane: A Molecular Simulation Study

Non-equilibrium Molecular Dynamics Simulation on Pure Gas Permeability Through Carbon Membranes

Proton Transport, Electroosmotic Drag and Oxygen Permeation in Polytetrafluoroethylene Reinforced Ionomer Membranes and Their Effects on Fuel Cell Performance

Molecular Dynamics Simulation of the Mechanical Properties and Thermal Conductivity of Aromatic Electrolytes in Proton Exchange Membrane Fuel Cells

An Analytical Model for Gas Leakage Through Contact Interface in Proton Exchange Membrane Fuel Cells

Effects of Cathode Gas Diffusion Layer Porosity and Contact Angle Distributions along Through-Plane Direction on the Performance of Polymer Electrolyte Membrane Fuel Cell

Structural and Transport Properties of Hydrophilic and Hydrophobic Modified Ionomers in Proton Exchange Membrane Fuel Cells

Pore scale study of heat and mass transfer in ice-containing gas diffusion layer of polymer electrolyte membrane fuel cells

Numerical and experimental characterization of gas permeation through membranes with consideration of mechanical degradation in proton exchange membrane fuel cells

Liquid Water Transport and Distribution in the Gas Diffusion Layer of a Proton Exchange Membrane Fuel Cell Considering Interfacial Cracks

Innovative Insight into O2/N2 Permeation Behavior through an Ionomer Film in Cathode Catalyst Layers of Polymer Electrolyte Membrane Fuel Cells