Abstract:An autonomous underwater vehicle (AUV) can be employed to estimate an underwater target’s position using the Doppler shift measurement extracted from received signals. Conventionally, the received signals have to be divided into several short frames so that the Doppler shift is constant in each one. When the AUV is far away from the target, the signal to noise ratio (SNR) is quite low. An intuitive solution is to increase the frame length to suppress noise and boost SNR. However, it is worth noting that the Doppler shift is actually changing over time, and the prolonged frame length will inevitably induce modeling error. This is a fundamental dilemma in the Doppler-shift-based underwater localization. In this paper, we reveal that the assumption of constant Doppler shift comes from the zero-th order Taylor expansion of the real-time model. To increase the frame length without jeopardizing the model accuracy, we modify the model by taking the first-order Taylor expansion. By doing so, the frame length can be prolonged by one order of magnitude without introducing non-negligible modeling error. What this new model says is that when the target broadcasts a single-tone signal, the AUV will receive a linear frequency modulated (LFM) signal parameterized by a Doppler shift and a corresponding changing rate, i.e., Doppler rate. Although the Doppler rate is very small, it helps us improve the estimation accuracy of Doppler shift. Besides, the Doppler rate also contains target’s position information. Thus, a two-phase localization algorithm is proposed by jointly using the Doppler shift and the Doppler rate measurements. Intuitively, the Doppler rate is only loosely related to the target’s position and should not significantly contribute to the localization accuracy, but the Cramér-Rao lower bound (CRLB) analysis says differently. This can be explained by showing that the Doppler rate complements the vanishing degree of freedom (DoF) in the position information for far-field localization, i.e., the information fusion. The theoretical results are verified through extensive simulations.

Passive Localization Method of LFM Signal Transmitter Based on Multi-channel Joint Accumulation in FrFT Domain

Passive Localization Based on Spectral Estimation Methods Using Sources of Opportunity

Passive Localization Based on Double-Correlation Function Using Sources of Opportunity

Joint estimation of location and signal parameters for an LFM emitter

Passive location using inter-array model-based processing

An Iterative Direct Position Determination Approach Based on Doppler Frequency Shifts

Efficient Localization of Low-Frequency Sound Source with Non-Synchronous Measurement at Coprime Positions by Alternating Direction Method of Multipliers.

Single-Anchor Passive Localization Of Full-Duplex Agents

On the Accuracy of Passive Source Localization Using Acoustic Sensor Array Networks

Multi-Sensor Passive Localization Using Direct Position Determination With Time-Varying Delay

Device-free Localization using Received Signal Strength Measurements in Radio Frequency Network

Joint Target and Transmitter Localization With AOA and DTD Using Passive Sensors

High-Precision Positioning with Continuous Delay and Doppler Shift using AFT-MC Waveforms

Enhancing the Performance of Indoor Device-Free Passive Localization

Distributed Passive Positioning and Sorting Method for Multi-Network Frequency-Hopping Time Division Multiple Access Signals

Device-Free Multitarget Localization With Weighted Intersection Multidimensional Feature for Passive UHF RFID

A novel non-direct multipath based single-sensor passive localization method

TDLoc: Passive Localization for MIMO-OFDM System Via Tensor Decomposition

High-Precision Joint TDOA and FDOA Location System

High Accuracy AUV-Aided Underwater Localization: Far-Field Information Fusion Perspective

An Anti-Interference Method Based on Energy Residual Searching in GNSS Positioning Applications