Abstract:For offshore structures in service such as offshore platforms and offshore wind turbines, their displacements are expected but can be difficult to measure directly due to the lacking of fixed reference points in ocean. Aiming at obtaining displacements of offshore structures from accelerations which can be easily measured by accelerometers, a new non-integration displacement reconstruction method is proposed in this paper. The complex exponential series is adopted to establish a relationship between the measured acceleration and the targeted displacement. Compared to direct-integral or high-pass filtering methods, one theoretical development in the present approach is that the reconstructed displacement is derived from the estimated complex exponential parameters of measured acceleration signal with a form of fraction, and the components that cause the drift could be identified and removed, thus significantly reducing the drift issue typically experienced by traditional methods. Additionally, a challenging problem involving the estimation of velocity and displacement at the measured starting moment is solved, which implies that the noises contained in the measured acceleration signal will not be amplified during the conversion from acceleration to velocity and displacement. To investigate the performance of the proposed method, one numerical example and two physical experiments are carried out sequentially. The selected numerical example is a 4-dof system, which aims at verifying the correctness and investigating the robustness of the proposed method. Numerical results show: (1) velocities and displacements can be accurately reconstructed from noise-free acceleration signals with an obvious baseline offset; (2) even when the acceleration signals are contaminated with 15% Gaussian noise, a good estimation of velocities and displacements can still be obtained. Subsequently, a steel beam fixed on a shaking table is tested, and two accelerometers and two laser displacement sensors are used to measure the dynamic responses of the table as well as the top of the beam, respectively. The experimental results show a good agreement between the reconstructed displacements and the measured data from the laser displacement sensors. Finally, a four-leg offshore platform is investigated experimentally to assess the potential application of the present method in ocean engineering. It is observed from the experimental results that the maximum absolute difference in the amplitude between the reconstructed and measured displacements is 0.47 mm with the computed peak displacement error of 0.3166, which further confirms the feasibility and correctness of the proposed method.

Dynamic Strain Field Estimation of Fixed Offshore Support Structures Using Limited Acceleration Measurements

A Method to Predict Structural Dynamic Strain Based on Acceleration Signal

Predicting Structure Dynamic Acceleration Based on Measured Strain

Strain response estimation for the fatigue monitoring of an offshore truss structure

An Output‐only Structural Condition Assessment Method for Civil Structures by the Stochastic Gradient Descent Method

Displacement Estimation from Measured Acceleration for Fixed Offshore Structures

Dynamic displacement estimation and modal analysis of long-span bridges integrating multi-GNSS and acceleration measurements

Improvement Study of Modal Analysis for Offshore Structures Based on Reconstructed Displacements

Dynamic strain measurement of large scale structures

Dynamic deformation monitoring of an offshore platform structure with accelerometers

Reference-free absolute strain estimation using longitudinal waves and relative strain measurements

Global Displacement Reconstruction of Lattice Tower Using Limited Acceleration and Strain Sensors

Unsupervised statistical estimation of offshore wind turbine vibration for structural damage detection under varying environmental conditions

Structural health monitoring of offshore wind turbines using distributed acoustic sensing (DAS)

A streamline approach to multiaxial fatigue monitoring using virtual sensing

Multi-rate Data Fusion for Dynamic Displacement Measurement of Beam-Like Supertall Structures Using Acceleration and Strain Sensors

Fatigue Stress Estimation for Submerged and Sub-Soil Welds of Offshore Wind Turbines on Monopiles Using Modal Expansion

Preliminary Test for 3D Surface Strain Measurement in the Tower and Foundation of Offshore Wind Turbines Using DOFS

Full-field dynamic strain reconstruction of an aero-engine blade from limited displacement responses

Periodic Damage Evaluation of Aging Offshore Jackets Based on Continuous Dynamic Tests

Structural monitoring for lifetime extension of offshore wind monopiles: Verification of strain-based load extrapolation algorithm