Abstract:External-rotor dual-armature flux-switching PM (ER-DA-FSPM) machines have high torque density and decent fault tolerance, making them promising candidates for in-wheel machine applications in electric vehicles. The torque output and optimal design parameters of ER-DA-FSPM machines are affected by the stator/rotor torque ratio, which is the focus of this paper. Firstly, this paper analyzes airgap flux density harmonics of ER-DA-FSPM to provide a clear insight into the torque-generation mechanism. Then, this paper investigates the influence of torque ratio on average torque under the same copper loss. It is found that the average torque decreases with torque ratio increasing due to the reduction of the positive torque component generated by the sixth airgap field harmonics and the rise in the negative torque component from the eighth harmonics. Moreover, this paper also provides the optimal parameter recommendation to guide the machine design. The split ratio should increase, and the arc of PMs should decrease for a larger torque ratio, whilst the other parameters are hardly influenced. Next, this paper makes a comparison among the ER-DA-FSPM machine, external rotor flux-switching PM (ER-FSPM) machine, and surface-mounted PM (ER-SPM) machines. It shows that the ER-DA-FSPM machine, with the torque ratio being 2, can lead to a much larger total torque. In addition, in the event of rotor winding failure, which is more possible due to the existence of slip rings than stator winding failure, the stator can still provide an average torque larger than that of ER-SPM machine and 92.0% that of the ER-FSPM machine, respectively. Finally, the theoretical analysis is verified by the experiments.

The Evaluation of Optimal Ratio of Outer Diameter to Axial Length on Torque Density for the External Rotor PMSM

Comparison of Optimal Design and Performance of PM Machines Having Non-Overlapping Windings and Different Rotor Topologies

Analytical determination of optimal split ratio for overlapping and non-overlapping winding external rotor PM brushless machines

Influence of Design Parameters on Output Torque of Novel Doubly-Fed Flux-Switching Permanent Magnet Machines

Optimal Split Ratio in Fractional-Slot Interior Permanent-Magnet Machines With Non-Overlapping Windings

Influence of Key Parameters on Torque to Mass Ratio in Surface-Mounted PM Machines with Non-Overlapping Windings

Efficiency Optimization of PMSM Drives Using Field-Circuit Coupled FEM for EV/HEV Applications

Design Optimization with Outer Rotor Interior Permanent Magnet Synchronous Motor with Hybird Permanent Magnet

Optimized Design of High Torque Density Permanent Magnet Synchronous Motor with Halbach Magnet

Influence of Stator/Rotor Torque Ratio on Torque Performance in External-Rotor Dual-Armature Flux-Switching PM Machines

Nonlinear Analytical Model-Embedded Optimal Design for ER-PMSM

Comparison of PMSMs with Different Rotor Structures for EV Application

Optimal Design of Outer Rotor Interior Permanent Magnet Synchronous Machine with Hybrid Permanent Magnet

Design and analysis of high power density permanent magnet-assisted synchronous reluctance motor

Design and Analysis of Outer Rotor Permanent-Magnet Vernier Machines with Overhang Structure for In-Wheel Direct-Drive Application

Nonlinear Analytical Analysis of External Rotor Permanent Magnet Synchronous Motor

Electromagnetic Optimization of Tangential Rotor for a Low-Speed High-Torque Permanent Magnet Motor

Investigation of a 3D-Magnetic Flux PMSM with High Torque Density for Electric Vehicles

Optimal Split Ratio for High Torque Density PM Machines Based on Analytical Determination

Optimal Design of an Interior Permanent Magnet Synchronous Motor for Electrical Vehicle Applications

Optimal Design of an Axial Flux Permanent Magnet Motor