Abstract:Nano-sized Scandia Doped Dispenser cathode made from Scandia doped tungsten powder has been paid worldwide attention due to its high emission and satisfactory emission uniformity. Among the adopted doping techniques the liquid-liquid doping by Sol-Gel process is the most favorable for the performance of this kind of cathode. A further searching on the details of the processes is necessary for cathode manufacturing. In this study, Sc 2 O 3 contents of 1%wt., 3%wt., 5%wt. and 7%wt. (named Sc1, Sc3, Sc5 and Sc7) were added to the tungsten powder; their effects on microstructures and emission performance of the produced cathodes were investigated. The study proved that the nano-sized Sc 2 O 3 particles are getting richer from Sc1 to Sc7 but cover on the W grains in all cases. While there is a slight decrease in porosities from Sc1 to Sc7, the filled impregnant of Ba Ca aluminates for Sc1 to Sc5 is satisfied the requirement for dispenser cathode, but is obviously lower for Sc7. All cathodes made from Sc3, Sc5 and Sc7 reach a Space Charge Limited current density of about 50A/cm 2 at true temperature of 960°C except Sc1 of 33A/cm 2 . The knee points at initial current density of 30A/cm 2 are 830C, 875°C and 920°C for Sc5, Sc3 and Sc7, respectively. Almost no knee can be observed for Sc1. Therefore, Sc5 and Sc3 exhibit the best emission and emission uniformity, Sc7 comes second and Sc1 goes the worst.

Thermionic Electron Emission Capacity of the Ba $_{\text{3}}$ ScGa $_{\text{2}}$ O $_{\text{7.5}}$ Impregnated Cathode

Thermionic Emission Capability of the Ba–Sc–Al–O Compound Synthesized by High-Temperature Solid-State Process

Single-phase (ba,ca)2scalo5 Impregnant for Dispenser Cathodes with Enhanced Thermionic Emission Performance

Preparation of Scandium Dispenser Cathode by Microwave Sintering and Its Electron Emission Property

Investigation of Sc<inf>2</inf> O<inf>3</inf> contents for nano-sized Scandia doped dispenser cathode

Emission Mechanism of High Current Density Scandia-Doped Dispenser Cathodes

Sc-Containing (Scandate) Thermionic Cathodes: Mechanisms for Sc Enhancement of Emission

Effect of Sc2O3 Addition on the Phase Composition and Electron Emission Performance of Co-precipitated Aluminates for Impregnated Cathodes

Vacuum Evaporation Synthesizing Sc Film Layer and Elucidation of Near-Surface Ba-O-Sc Electronic Configuration for Dispenser Cathode

Investigation of Sc2O3 Contents for Nano-sized Scandia Doped Dispenser Cathode

Sc2O3–W matrix impregnated cathode with spherical grains

A Review of Sc-containing "Scandate" Thermionic Cathodes

Investigation on Scadium Thin Films on Dispenser Cathodes

The effect of Ir and Sc on the emission capacity of W–Ir matrix scandate cathodes prepared via a novel in situ method

Preparation and Emission Property of Scandia Pressed Cathode

Intrinsic defects and conduction characteristics of $Sc_2O_3$ in thermionic cathode systems

A review on scandia doped tungsten matrix scandate cathode

Enhancing the thermionic electron emission performance of hafnium with nanocluster doping

Study on Scandia Mixed Matrix Impregnated Cathode in Microstructure and Properties

Cathodoluminescence Properties of Ba3Si6O9N4:Eu2+ Phosphors

Fabrication of Aluminate for Scandia Doped Dispenser Cathode and Emission Property