Abstract:Reconfigurable intelligent surface (RIS) has been regarded as a promising technique due to its high array gain, low cost, and low power. However, the traditional passive RIS suffers from the “double fading” effect, which has become a major bottleneck in restricting the performance of passive RIS-aided communications. Fortunately, active RIS can alleviate this problem by adjusting the phase shift and amplifying the received signal simultaneously. Nevertheless, a high beamforming gain often requires a large number of reflecting elements, which leads to non-negligible power consumption, especially for the active RIS. Thus, one challenge is how to improve the scalability of the RIS and the energy efficiency. Different from the existing works where all reflecting elements are activated, we propose a novel element on-off mechanism where reflecting elements can be flexibly activated and deactivated. To achieve a tradeoff between the transmission rate and energy consumption, two different optimization problems for passive RIS and active RIS are formulated by maximizing the total energy efficiency, where the constraints of the maximum power of users and the RIS, the minimum transmission rate, the element on-off factor, and the unit moduli of passive elements are taken into account. In light of the intractability of the formulated problems, we develop two different alternating optimization-based iterative algorithms by combining quadratic transform, variable substitution, and the successive convex approximation method to obtain sub-optimal solutions. Furthermore, in order to gain more insight into problems, we consider special cases involving transmission rate maximization problems for given the same total power budget, and respectively analyze the number configuration for passive RIS and active RIS. Simulation results verify that the proposed algorithms outperform existing algorithms, and reflecting elements under the proposed algorithms can be flexibly activated and deactivated.

Can Series or Parallel Switches Improve the Performance of Reconfigurable Reflectarray Elements?

A Study of Reconfigurable Array Elements with a Single Switch Based on Three-Port Network Theory

Is It Possible to Design a 1-Bit Reconfigurable Transmitarray Element with a Single Switch?

A Radiation Viewpoint of Reconfigurable Reflectarray Elements: Performance Limit, Evaluation Criterion and Design Process

Transmission efficiency limit of single-switch and cascaded reconfigurable transmitarray elements

One‐bit Wideband Reconfigurable Reflectarray with Stable Beam‐scanning Gain for X‐band Application

A 1-bit Reconfigurable Reflectarray Element with Independent Dual-band Phase Controlling Capability

Analysis and optimization of the scanning performance of 1-bit reconfigurable reflectarrays

A Study of Phase Quantization Effects for Reconfigurable Reflectarray Antennas

A Subwavelength 1-Bit Broadband Reconfigurable Reflectarray Element Based on Slotting Technology

A Study of Four-Switch Cross-Shaped RIS and A Novel Design Example

A 1-Bit $10 \times 10$ Reconfigurable Reflectarray Antenna: Design, Optimization, and Experiment

Design Of A 2-Bit Reconfigurable Reflectarray Element Using Two Mems Switches

A 1600-Element Dual-Frequency Electronically Reconfigurable Reflectarray at X/Ku-Band

A 2-Bit Reconfigurable Reflectarray Unit Design Using Only 2 PIN Diodes

Design Of A Terahertz Reconfigurable Reflectarray With Individually Controlled 1-Bit Phasing Elements

To Reflect or Not To Reflect: On-Off Control and Number Configuration for Reflecting Elements in RIS-Aided Wireless Systems

Millimeter Wave Communications With Reconfigurable Intelligent Surfaces: Performance Analysis and Optimization

Design of Multi-bit Reflective Metasurface Element Based on SP4T RF Switch

Reconfigurable Reflectarrays and Transmitarrays: from Antenna Designs to System Applications