Abstract:Three-dimensional (3D) measurement based on structured light, as a non-contact, active, and high-precision measurement technology, is widely applied in the diverse fields of industrial detection, face recognition, reverse engineering, and so on. We adopted an adjustable grating-stripe coding as the dynamic structured-light mode, which can continuously cover the entire measured surface to guarantee high accuracy. A one-axis resonant-mode MEMS mirror combined with a linear laser was used to project the desired adjustable grating stripes, leading to a miniaturized module size. To make the scanning angle of the MEMS mirror matching the intensity distribution of the linear laser, we further introduced a single-chip microcomputer (STM32) to receive the feed-back signals from MEMS mirror, and synchronously controlled the laser power with corresponding function relationship output. Here, the MEMS mirror could provide a resonant frequency of 1.15 kHz, a scanning optical angle of +/- 30 degrees, a feed-back scanning-angle resolution of 0.05 degrees, and a reflected mirror size of 3 mm-diameter circle, respectively. Also, the laser source could generate a line width of 70 mu m at a 300 mm focused distance. To decrease the error in the energy amplitude of each cycle of the structured light stripes, the empirical mode decomposition (EMD) was used to perform principal component analysis and recombination of the structured light stripes. In addition, total harmonic distortion (THD) is used to evaluate the quality of structured light stripes. Finally, the structured light based on the scanning of the MEMS mirrors exhibits a good sinusoidal stripes and high refresh rate, implying high adaptivity for the 3D reconstruction.

One-Shot Three-Dimensional Measurement Based on Spectral Interferometry Using a Digital Micromirror Device

Single-Shot Two-Dimensional Surface Measurement Based On Spectrally Resolved White-Light Interferometry

Quantitative Phase Imaging Based on Wavefront Correction of a Digital Micromirror Device

Panoramic Three-Dimensional Optical Digitization System Assisted by a Bi-Mirror.

High dynamic range spatial heterodyne one-dimensional imaging spectroscopy based on a digital micromirror device

Compression-coding-based Surface Measurement Using a Digital Micromirror Device and Heterodyne Interferometry of an Optical Frequency Comb.

Fast 3D super-resolution imaging using a digital micromirror device and binary holography

Hyperspectral imaging via a multiplexing digital micromirror device

Single-shot 3D imaging with point cloud projection based on metadevice

No-scanning 3D measurement method using ultrafast dimensional conversion with a chirped optical frequency comb

MEMS-mirror-based Dynamic Structured Light Projection System for Three-Dimensional Measurement with High Precision

Single-pixel real-part and magnitude imaging system based on digital micromirror device

Innovative full-field chromatic confocal microscopy using multispectral sensors

Interferometric Time-Stretch Microscopy for Three-Dimensional Microstructure Recognition

Single-Shot 3D Imaging Meta-Microscope

A Novel 360-Degree Shape Measurement Using A Simple Setup With Two Mirrors And A Laser Mems Scanner

Ultrafast Three-Dimensional Surface Imaging Based on Short-Time Fourier Transform

Single-frame measurement of the complete spatiotemporal field of ultrafast laser pulses using Carrier Frequency-Division Multiplexing Spectral Interferometry

Full-field spectral-domain optical interferometry for snapshot three-dimensional microscopy

A Snapshot Infrared Imaging Fourier Transform Spectrometer for Dynamic Target Detection

Swept-Angle Synthetic Wavelength Interferometry