Ambient Pressure Carbonation Curing of Cold-bonded Fly Ash Lightweight Aggregate Using Coal-fired Flue Gas for Properties Enhancement and CO2 Sequestration

Xiaoyan Yao,Bing Song,Qun Huan,Yue Hu,Min Song

DOI: https://doi.org/10.1016/j.jece.2024.114208

IF: 7.7

2024-01-01

Journal of Environmental Chemical Engineering

Abstract:In the current CO2 curing process, pure CO2 gas with a concentration exceeding 99% is primarily used. However, flue gas, which typically contains 10-30% CO2, can also be utilized for carbonization. This study sought to explore the viability of employing flue gas for carbonation and assessed the impact of impurity gases such as SO2. Two typical industrial solid wastes (fly ash and coal gangue) were used to substitute a portion of the cement to prepare light aggregates, which were carbonized under varying concentrations of CO2 and SO2. The porosity and water absorption of the samples decreased after carbonation. A higher degree of carbonation was observed at increasing CO2 concentration. Aggregates carbonated with 15% CO2 improved the CO2 absorption by 48%. The actual CO2 uptake reached up to 58.3% of the theoretical value. The presence of SO2 has been found to impact the uptake of CO2. The CO2 uptake initially declined and then increased as the SO2 concentration increased. The existence of SO2 led to varied increases in the leaching concentrations of the aggregates following the process of carbonation, and some even exceed standard limits. In the presence of both CO2 and SO2, SO2 reacted with the aggregates, resulting in the creation of calcium sulfate. This reaction disrupted the structure of the aggregate, facilitating the diffusion of CO2 into the samples.