Abstract:Increasing demands for high-performance screw pumps in oil and gas as well as other applications require deep understanding of the fluid flow field inside the machine. Important effects on the performance such as dynamic losses, influence of the leakage gaps and presence and extent of cavitation are difficult to observe by experiments. However, it is possible to study such effects using well-validated computational fluid dynamics models. The novel-structured numerical mesh consisting of a single-computational domain for moving screw pump rotors was developed to allow three-dimensional computational fluid dynamics simulation of such machine possible. Based on finite volume method, the instantaneous mass flow rates, rotor torque, local pressure field, velocity field and other performance indicators including the indicated power were predicted. A calculation model for the bearing friction losses was introduced to account for mechanical losses. The geometry of the inlet and outlet passages and piping system are taken into consideration to evaluate their influences on the pressure distribution and shaft power. The paper also shows the influence of rotor clearances on the pump performance. The computational fluid dynamics model was validated by comparing the numerical results with the measured performance obtained in the experimental test rig through the comprehensive experiment performed for a set of discharge pressures and rotational speeds. Validation includes comparison of mass flow rates, shaft power and efficiency under variety of speeds and discharge pressure. It has been found that the predicted results match well with the measurements. The results also showed that the radial clearances have larger influence on the mass flow rate than the interlobe clearance. The correct design of the flow passages within the screw pump plays significant role in minimizing required power consumption. The analysis presented in this paper contributes to better understanding of the working process inside the screw pump and offers a good reference to improve design and optimize such machines in terms of clearance selection, shape of the ports, piping system, etc. In future, this model will be used for analysis of cavitating flows and determining performance of other multiphase screw pumps.

Numerical Investigation of Performance and Multiparameter Prediction Model of High-Pressure Fuel Filters and Cavitation at Filtration Orifices Considering Variable Fluid Properties

Numerical Simulation of the Cavitation Characteristics of A Mixed-Flow Pump

Investigation of the Enhanced Cavitation Model Considering Turbulence Effects of Fuel Flow in the Injector Nozzle Holes

Cavitation Performance Improvement of High Specific Speed Mixed-Flow Pump

Numerical Study on the Cavitation Flow Characteristics of High-Pressure Fuel in Injector Orifices Based on Compressible Non-Isothermal Model

Numerical examination of high-pressure fuel injection in common rail injector based on hydro-mechanical model

Lumped model for evaluating dynamic filtration and pressure drop behaviour in diesel particulate filters

A Numerical and Experimental Investigation of Parametric Effect on Flow Ripple

Numerical Prediction of Performance Drop Due to Cavitation in a Centrifugal Pump

Numerical investigation of cavitating flows in bulb tubular pump and its performance prediction

Numerical simulation of diesel particulate filter flow characteristics optimization: From the perspective of pore structure parameters and inlet velocity

Numerical calculation and optimization designs in engine cooling water pump

Numerical Prediction Of The Hydrodynamic Performance Of A Centrifugal Pump In Cavitating Flows

Investigation of the filtration performance for fibrous media: Coupling of a semi-analytical model with CFD on Voronoi-based microstructure

Numerical Study on Flow Characteristics of Rotor Pumps Including Cavitation

Numerical modelling of twin-screw pumps based on computational fluid dynamics

Optimization on the performance of fibrous filter through computational fluid dynamic simulation coupled with response surface methodology

Numerical Simulation on Flow Dynamics and Pressure Variation in Porous Ceramic Filter

Simulation of Cavitation Effects on DME Injection Characteristics

Numerical Prediction of Hydrodynamic Performance of Centrifugal Pump under Attached Cavitating Flows

Numerical Investigation on the Hydrodynamic Performance with Special Emphasis on the Cavitation Intensity Detection in a Venturi Cavitator