Abstract:Desiccation cracking is a common phenomenon on Earth's surface. It is a typical form of soils' tensile failure caused by drying-induced tensile stress. Understanding soil tensile behavior during the drying process is of great significance for revealing the soil desiccation cracking mechanism. In this investigation, fiber Bragg grating (FBG) technique was employed to develop a new restrained ring, which is able to continuously monitor the evolution characteristics of soil tensile strain as well as tensile stress during the desiccation cracking process. Desiccation tests were carried out on two clayey soils (a lean clay and a fat clay). Saturated slurry samples (inside radius of 25 mm, outside radius of 75 mm and height of 30 mm) were prepared with initial water contents of 58.1% for the tested lean clay and 106.6% the tested fat clay, and were subjected to continuous drying under constant environmental condition (25 +/- 1 degrees C of room temperature, 50 +/- 5% of relative humidity). Moreover, a camera was mounted above the soil sample to capture the surface changes as well as the initiation and propagation of desiccation cracks. The results show that the developed FBG-based restrained ring can effectively identify the tensile behavior of the soil during the desiccation cracking process. Both the evolution of tensile stress and graphic variation show three typical periodic features that are well matched with soil vertical deformation, lateral shrinkage and cracking. With decreasing water content, tensile stress gradually increases at first and then increases more rapidly. Once the tensile stress reaches the peak value, desiccation cracks initiate and a sudden reduction in tensile stress is observed. Finally, the tensile stress reaches a residual stage. We consider the maximal tensile stress during the drying process to correspond to the tensile strength of the tested material. It is found that clay content has a significant influence on the cracking tensile strength of soils. The fat clay with a higher clay content shows a larger cracking tensile strength (about 410 kPa) compared with the lean clay (about 90 kPa).

Thermal Effects on Tensile Strength of a Compacted Soil

Effects of Moisture Content and Dry Bulk Density on the Thermal Conductivity of Compacted Backfill Soil

Tensile Strength of Compacted Clayey Soil

Influence of Desiccation During Freeze-Thaw Cycles on Volumetric Shrinkage and Tensile Strength of Compacted Clayey Soils

Effect of Different Moisture Content on Mechanical Parameters of Red Clay Under Freeze-Thaw Cycle

Effects of Compaction State on Structural Strength of a Clayey Soil As Determined by Micropenetrometer Tests

Effect of Suction Change on Water Content and Total Volume of an Expansive Clay

A Study of the Effect of Temperature on the Structural Strength of a Clayey Soil Using a Micropenetrometer

Test Research on Tensile Properties of Compacted Clay

Effects of Microstructure on Desiccation Cracking of a Compacted Soil

Coupled Effects of Matric Suction and Temperature on the Compression Behaviour of Loess

Desiccation Cracking Behavior of a Clayey Soil with Different Compaction States

Measurement Of Tensile Strength Of Clayey Soil During Drying And Cracking

Effects of Soil Structure on Thermal Softening of Yield Stress

Tensile Strength of Clayey Soil and the Strain Analysis Based on Image Processing Techniques

Effects of Compaction State on Desiccation Cracking Behaviour of a Clayey Soil Subjected to Wetting-Drying Cycles

Tensile Strength Identification of Remolded Clayey Soils

Tensile Behavior of Clayey Soils During Desiccation Cracking Process

THE INFLUENCE OF HEATING AND COOLING ON THE STRUCTURAL STRENGTH OF A CLAYEY SOIL

Experimental and Numerical Investigation on the Tensile Fracture of Compacted Clay

Modeling Temperature-Dependent Behavior of Soft Clay