Abstract:In the process of underground construction, it is common to spray concrete on the working surface, which will form a concrete-rock composite structure, to achieve the expected reinforcement effect. Compared with pure concrete or rock structures, composite structures have different mechanical properties, energy evolution and damage characteristics. Understanding the dynamic mechanics and damage characteristics of composite structures under impact loads is important to the safety of underground engineering construction. First, dynamic compression tests on different grades of mortar-sandstone composite specimens were carried out by using a Hopkinson pressure bar system to discuss the effect of impact velocities on the mechanical properties and failure modes of composite specimens. The results show that the dynamic peak stress, strain energy density and fragmentation block of the mortar-sandstone composite have an obvious strain rate effect. With an increase in impact velocity, the internal cracks of the sample do not have sufficient time to expand, and the energy absorbed by the sample leads to the continuous initiation of new cracks in the sample, resulting in an increasing damage degree of composite specimens. The increase in mortar strength can significantly increase the peak stress, improve the load-bearing capacity of the sample, and reduce the degree of sample damage. At the same impact velocity, the fragmentation degree of the mortar sample is more severe than that of sandstone, and the mortar sample is broken into powder debris, while the sandstone is broken into fragments. In addition, according to the failure properties of the composite sample, the mortar and sandstone samples are described by different damage models, and the dynamic damage constitutive model of the mortar-sandstone composite is established based on the overlay principle. The dynamic test results were fitted. The research shows that the fitting curves of the model are well fitted with the test curves and that the model accurately reflects the changes in the mechanical parameters of the composite specimens.

Experimental Study on Mechanical Properties of Low-Strength Mortar–Granite Composite Specimens

Experimental Study on Mechanical Properties of Basalt Fiber-Clay Lime Mortar and Application in Brick Masonry

Mesoscopic numerical test of crushing process of concrete under uniaxial compression

Rheological properties of mortar and concrete with low binder content

Fundamental Mechanical Behavior of CMMOSC-S-C Composite Stabilized Marine Soft Clay

A Study on the Mechanical and Wear-Resistance Properties of Hybrid Fiber Mortar Composites with Low Water-Cement Ratios

Experimental study on axial compressive behavior of stone masonry with ultra-high performance mortar

The Mechanical Properties of Polymer-cement Mortar

Investigation on Hydration and Mechanical Properties of Mortar Containing Limestone Powder and Fly Ash Based on the Coupled Chemical–Thermal–Mechanical Method

Dynamic and Damage Characteristics of Mortar Composite under Impact Load

Compression failure conditions of concrete-granite combined body with different roughness interface

Investigations on the Preparation and Mechanical Properties of the Nano-Alumina Reinforced Cement Composite

Elementary Behavior of Dual-Particle Composites Cemented by Self-Compacting Mortar: Experimental and Constitutive Modelling

Experimental Study on Mechanical Properties and Failure Laws of Granite with Artificial Flaws under Coupled Static and Dynamic Loads

Experimental Study on the Dynamic Fracture Characteristics of Mortar–Rock Interface Zones with Different Interface Inclinations and Shapes

Large scale experimental study on bond behavior between polymer modified cement mortar layer and concrete

Study on dynamic fracture behaviour and fracture toughness in rock-mortar interface under impact load

Experimental Study on the Mechanical Performance of Grouted Specimen with Composite Ultrafine Cement Grouts

Study on the shear properties of masonry pagoda mortar and its influencing factors

Dynamic compressive and splitting tensile tests on mortar using split Hopkinson pressure bar technique