Experimental Study of Heat Loss and Heat Feedback of Pool Fire of Millimeter to Centimeter Fuel Thickness

Chen Wang,Jie Ji,Albert Simeoni,Jingbo Xu,Hao Zhang

DOI: https://doi.org/10.1016/j.proci.2024.105758

IF: 6.535

2024-01-01

Proceedings of the Combustion Institute

Abstract:The leaked liquid fuel has the potential to form a pool fire due to the boundary. The thickness of the fuel (delta) may transition from the millimeter-level to the centimeter-level over time as it leaks. In cases where the pool fires have a delta at the millimeter-level, it is important not to ignore heat loss from the fuel to the substrate, as this can significantly impact both heat transfer and heat feedback evolution. Experiments were conducted to investigate the heat loss and feedback of n-heptane pool fires with varying delta and pool diameters (D). Results showed that the fuel burning rate remains constant whereas delta will vary if the flame is in the steady burning stage. As delta increases, both convection and radiation losses absorbed by the substrate decrease rapidly before decreasing slowly. Smaller values of delta or larger D can result in a greater percentage of heat loss. The effect of heat loss on heat feedback was revealed, and a dominant control mechanism (DCM) for heat feedback was identified for values of delta ranging from millimeters to centimeters with D. As D increases, when delta <= 5.0 mm, DCM transits from convection to radiation; when delta=5.0 similar to 10.0 mm, DCM transits from radiation to convection, then to radiation; when delta >= 10.0 mm, DCM transits from conduction to convection, then to radiation again. As delta increases, when D <= 5.0 cm, DCM transits from convection to radiation, then to conduction; when D continues to increase, DCM is always convection (D = 5.0 similar to 10.0 cm) or transits from convection to radiation (D = 10.0 similar to 20.0 cm). When D >= 20.0 cm, DCM is always radiation.