Preparation of carbon nanostructures from medium and high ash Indian coals via microwave-assisted pyrolysis

B. Rajasekhar Reddy,Ila Ashok,R. Vinu
DOI: https://doi.org/10.1016/j.apt.2019.12.017
IF: 4.969
2020-03-01
Advanced Powder Technology
Abstract:<p>This study is focused on valorizing low value and low quality Indian coals via microwave pyrolysis to produce good quality carbon nanostructures in the heat-treated coal char. The effects of operating conditions such as coal type, coal:susceptor (Fe) mass ratio, and microwave power on product yield and quality are evaluated. The quality of the heat-treated coal char was assessed using different characterization techniques such as electron microscopy, porosimetry, X-ray diffraction, and Raman spectroscopy. The addition of Fe enhanced the heating rates, and led to the formation of carbon nanotubes and nanoparticles. Increasing the proportion of Fe resulted in increase in size of nanotubes and nanoparticles, which is attributed to the fusion of small tubes and particles caused by enhanced localized heating. The yield of carbon nanostructures was more from medium ash (∼45%) than from high ash coal (∼37%) due to the high fixed carbon and low ash content in the former. In addition to char, coal tar and non-condensable gases were characterized. The major compounds in the coal tar were aromatic hydrocarbons, simple phenols and aliphatic hydrocarbons. Hydrogen and methane were the major gases from medium ash coal, while methane and CO were produced in significant quantities from high ash coal. Microwave-assisted pyrolysis is shown to be a promising process to produce carbon nanostructures in a short time period as compared to conventional thermal processes.</p>
engineering, chemical
What problem does this paper attempt to address?