Reinforced Co-Leaching of REEs/Nb/Ti from Low-Grade Concentrate Mixture: Decomposition Behavior and Co-Leaching Mechanism

Yubo Ge,Xinbing Xia,Louyan Shen,Guiqing Zhang,Qinggang Li,Shengxi Wu,Zhiyong Gao
DOI: https://doi.org/10.1016/j.mineng.2024.108920
IF: 5.479
2024-01-01
Minerals Engineering
Abstract:Baerzhe ore deposit is rich in such critical elements as rare earth elements (REEs), niobium (Nb), and titanium (Ti). However, in this ore, the REEs/Nb/Ti-bearing minerals are interlocked closely and thus not easily liberated and separated from each other by mineral processing methods. In order to achieve high recoveries of these critical elements, a concentrate mixture of REEs/Nb/Ti minerals can be obtained through gravity/magnetic separation and flotation to discard most of the gangue minerals. And then the Fe2(SO4)3-H2SO4 2 (SO 4 ) 3-H 2 SO 4 roasting and H2O 2 O leaching of REEs/Nb/Ti from the concentrate mixture by hydrometallurgical method was investigated in this work. The results showed that Nb/Ti-bearing minerals convert to Nb2O4SO4/TiOSO4 2 O 4 SO 4 /TiOSO 4 in the H2SO4 2 SO 4 roasting process and then readily hydrolyze to Nb(OH)5/Ti(OH)4 5 /Ti(OH) 4 in the H2O 2 O leaching process. When Fe2(SO4)3 2 (SO 4 ) 3 is introduced into the H2SO4 2 SO 4 roasting process, the solubility and leaching efficiency of Nb/Ti increases significantly by the generation of soluble Fe-Nb/Fe-Ti sulfates and coordination-enhanced leaching of sufficient SO 4 2- . REEsbearing minerals are still converted to RE2(SO4)3 2 (SO 4 ) 3 in the Fe2(SO4)3-H2SO4 2 (SO 4 ) 3-H 2 SO 4 roasting, achieving co-leaching of REEs/Nb/Ti during H2O 2 O leaching. Under optimal conditions, with a roasting temperature of 300 degrees C, a mass ratio of H2SO4 2 SO 4 to concentrate mixture of 1.0 g/g, a roasting time of 3 h, a mass ratio of Fe2(SO4)3 2 (SO 4 ) 3 to concentrate mixture of 0.1 g/g, a leaching temperature of 40 degrees C, and a leaching time of 3 h, the co-leaching efficiencies of REEs, Nb, and Ti reached 97.76 %, 87.97 %, and 90.82 %, respectively. This new method improves the recovery of REEs/Nb/Ti with good selectivity and relatively low cost, providing a new idea for the efficient exploitation and utilization of low-grade polymetallic ore.
What problem does this paper attempt to address?