Research on an Inlet-Engine Hybrid Integrated Modelling Method with Pressure Dynamic Self-Tuning

Tingyi Ouyang,Yi Liu,Zexi Jin,Huihui Miao,Jia Geng,Jinxin Liu,Yuan Ma,Zhiping Song
DOI: https://doi.org/10.1016/j.ast.2024.109501
IF: 5.457
2024-01-01
Aerospace Science and Technology
Abstract:With aircraft flying faster and higher, the interaction between the inlet and engine cannot be ignored. The inlet engine integration characteristics must be considered in engine design and performance evaluation. The total pressure between the inlet and compressor is a critical parameter that directly affects the accuracy of engine performance evaluation. The traditional solution to inlet-engine integrated modelling is to add an external balance equation to the component-level model (CLM), which may reduce real-time performance. In this study, an inlet-engine hybrid integrated modelling (IEHIM) method is proposed to solve this problem, which combines the advantages of the volume effect model and the CLM method. The proposed IEHIM method consists of an engine model, characteristics of the inlet component, and a pressure dynamic self-tuning (PDST) algorithm. The PDST algorithm coefficients were optimised to enhance the performance of the IEHIM method. Finally, the effectiveness of the IEHIM was verified through simulations and ground experiments. The method was also verified on an actual controller (operating frequency: 132 MHz), which exhibited a mass-flow matching error below 0.2% and an average time consumption of 5.191ms in each control cycle. The results were also compared with the actual experimental data, where the errors in the compressor entry total pressure and rotor speed were below 1.1520% and 1.2195%, respectively.
What problem does this paper attempt to address?