Abstract:Presented in this study is investigation of dynamic behavior of a helical gear reduction by experimental and numerical methods. A closed-loop test rig is designed to measure vibrations of the example system, and the basic principle as well as relevant signal processing method is introduced. A hybrid user-defined element model is established to predict relative vibration acceleration at the gear mesh in a direction normal to contact surfaces. The other two numerical models are also constructed by lumped mass method and contact FEM to compare with the previous model in terms of dynamic responses of the system. First, the experiment data demonstrate that the loaded transmission error calculated by LTCA method is generally acceptable and that the assumption ignoring the tooth backlash is valid under the conditions of large loads. Second, under the common operating conditions, the system vibrations obtained by the experimental and numerical methods primarily occur at the first fourth-order meshing frequencies and that the maximum vibration amplitude, for each method, appears on the fourth-order meshing frequency. Moreover, root-mean-square (RMS) value of the acceleration increases with the increasing loads. Finally, according to the comparison of the simulation results, the variation tendencies of the RMS value along with input rotational speed agree well and that the frequencies where the resonances occur keep coincident generally. With summaries of merit and demerit, application of each numerical method is suggested for dynamic analysis of cylindrical gear system, which aids designers for desirable dynamic behavior of the system and better solutions to engineering problems.

Dynamic Vibration Characteristics Analysis of Double Input Face Gear Split-Parallel Transmission System

Analysis of Vibration Characteristics of Face Gear powering-split Transmission System

Nonlinear Vibration Characteristics of Helical Bevel Gear Systemand Parameters Influences

Vibration characteristics analysis of face gear transmission system considering gyroscopic effect

Analysis of Nonlinear Vibration Characteristics of the Concentric Face-Gear Split-Torque Transmission System

Investigation of the Vibration Features and Dynamic Load Sharing Characteristics of Concentric Face Gear Torque Split Transmission

Non-linear Dynamic Analysis of an Internal Parallel Moving Gear System Driven by Single Parallel Moving Gear

Nonlinear Vibration Analysis of the Coupled Gear-Rotor-Bearing Transmission System for a New Energy Vehicle

Research on dynamic load sharing characteristics of double input face gear split-parallel transmission system

Vibration and noise analysis of gear transmission system

Study on nonlinear vibration and primary resonance characteristics of helicopter face gear-planetary gear coupling transmission system

Coupled nonlinear vibration analysis of a multi-stage gear transmission system

Numerical Modeling and Dynamic Characteristics Study of Coupling Vibration of Multistage Face Gearsplanetary Transmission

Research on Nonlinear Dynamic Performance of the Central Bevel Gear Transmission System in Aero-Engine with Complex Excitation

Nonlinear Vibration Characteristic Analysis of a Face-Gear Drive

Research on nonlinear dynamics and primary resonance characteristics of electric drive gear transmission system for clean propulsion vehicles

Coupled vibration modeling and dynamic characteristics of noncircular face gear drive system with time-varying instantaneous center excitation

Dynamic analysis and effects of nonlinear factors of a gear transmission system for high speed locomotive

Analysis of dynamic characteristics of a multi-stage gear transmission system

An Improved Model for Dynamic Analysis of a Double-Helical Gear Reduction Unit by Hybrid User-Defined Elements: Experimental and Numerical Validation

Vibration Characteristic Analysis of Helical Gear-rotor-bearing System with Coupled Lateral-torsional-axial