Abstract:Triggered by the introduction of higher frequencies (above 24 GHz), there has been a long-standing debate in the radio propagation community on whether higher frequency radio channels are sparser relative to channels below 6 GHz. Here, sparsity implies a few dominant multipath components containing the vast majority of the electromagnetic energy. This discussion has recently been revisited with the study and interest in bands above 100 GHz for future wireless access. In this paper, the level of sparsity is examined at 6, 26, and 105 GHz carrier frequencies by conducting channel measurements in an indoor office environment. By using the Gini index (value between 0 and 1) as a metric for characterizing sparsity, we show that increasing carrier frequency leads to increased levels of sparsity. The measured channel impulse responses are used to derive a Third-Generation Partnership Project (3GPP)-style propagation model, used to calculate the Gini index for the comparison of the channel sparsity between the measurement and simulation based on the 3GPP model. Our results show that the mean value of the Gini index in measurement is nearly twice the value in simulation, implying that the 3GPP channel model does not capture the effects of sparsity in the delay domain as frequency increases. In addition, a new intra-cluster power allocation model based on measurements is proposed to characterize the effects of sparsity in the delay domain of the 3GPP channel model. The accuracy of the proposed model is analyzed using theoretical derivations and simulations. Using the derived intra-cluster power allocation model, the mean value of the Gini index is 0.91 in the sub-THz band, while the spread of variability is restricted to 0.01, demonstrating that the proposed model is suitable for 3GPP-type channels. To our best knowledge, this paper is the first to perform measurements and analysis across a wide range of frequencies for the evaluation of channel sparsity in the same environment.

Channel Measurements and Sparsity Analysis for Air-to-Ground Mmwave Communications

Three-Dimensional Non-Stationary Geometry-Based Modeling of Sub-THz MIMO Channels for UAV Air-to-Ground Communications.

A UAV-Aided Real-Time Channel Sounder for Highly Dynamic Nonstationary A2G Scenarios

Measurement-based Channel Characterization for A2A and A2G Wireless Drone Communication Systems

3D Non-Stationary Channel Measurement and Analysis for MaMIMO-UAV Communications

Channel Sparsity Variation and Model-Based Analysis on 6, 26, and 105 GHz Measurements

Measuring Sparsity of Wireless Channels

A Measurement Study of Channel Dynamics in Wireless Mesh Networks

A Channel Measurement Campaign for mmWave Communication in Industrial Settings

Experimental Characterization of Air-to-ground Propagation at mm-Wave Frequencies in Dense Urban Environment

A Novel 3D UAV Channel Model for A2G Communication Environments Using AoD and AoA Estimation Algorithms

A LSE and Sparse Message Passing-Based Channel Estimation for Mmwave MIMO Systems.

Channel Characterization and Modeling for 6G UAV-Assisted Emergency Communications in Complicated Mountainous Scenarios

A Geometry-Based Stochastic Channel Model for UAV-to-Ground Integrated Sensing and Communication Scenarios

Ground-to-UAV sub-Terahertz channel measurement and modeling

Multi-Frequency Multi-Scenario Millimeter Wave MIMO Channel Measurements and Modeling for B5G Wireless Communication Systems

Path Loss Analysis for Low-Altitude Air-to-Air Millimeter-Wave Channel in Built-Up Area

An Experimental mmWave Channel Model for UAV-to-UAV Communications

Air-to-Ground Channel Modeling and Performance Analysis for Cellular-Connected UAV Swarm

Channel Measurement and Characterization with Modified SAGE Algorithm in an Indoor Corridor at 300 GHz

Near-Field Channel Characterization for Mid-band ELAA Systems: Sounding, Parameter Estimation, and Modeling