Abstract:The ongoing resurgence of severe Coal Workers' Pneumoconiosis in the US has been linked to overexposure to respirable crystalline silica (RCS, which is predominantly present as quartz and regulated as such). Capabilities that enable more frequent RCS monitoring are highly sought. Recent developments include field-based quartz analysis of traditional filter samples—collected on polyvinyl chloride (PVC) filters—using portable Fourier Transform Infrared spectroscopy (FTIR). However, most respirable dust samples in US coal mines are collected with a continuous personal dust monitor (CPDM) that enables real-time tracking of total respirable dust mass concentration. FTIR cannot directly analyze the collected dust sample due to the materials and construction of the sampling substrate. To address this issue, a simple three-step method was envisioned wherein the dust could be recovered into a suspension, redeposited onto a PVC filter using a syringe filter apparatus, and then analyzed by FTIR. The current study was conducted to develop the redeposition and analysis steps. It specifically considers the issues of the PVC filter size and deposition pattern yielded by typical filtration apparatuses and the FTIR scanning locations to establish a model that predicts quartz mass from the spectral data. Of the options tested here, the following combination was found to be optimal: 25-mm PVC filter with dust deposition using an inline syringe filter holder (which yields a "wheel and spoke" pattern), and FTIR analysis at four center-offset locations (90° apart, 8-mm from the center) from which the spectral data were averaged. Under these conditions, the predicted quartz mass on filters with respirable dust deposited from one of two geologic source materials (i.e., representing real coal mine silica sources) was observed to have a standard error of 0.011 mg (11 μg) for samples with an expected quartz mass of less than 0.150 mg (which equated to a total sample mass of less than about 1.5 mg). For samples with higher expected quartz masses, standard error increased, suggesting that dust deposition becomes less uniform with increasing total sample mass.

Functionalization of Filter Media for Improved Crystalline Silica Analysis Using Raman Spectroscopy

Evaluation of PVC and PTFE filters for direct-on-filter crystalline silica quantification by FTIR

An indirect Raman spectroscopy method for the quantitative measurement of respirable crystalline silica collected on filters inside respiratory equipment

Review of Filters for Air Sampling and Chemical Analysis in Mining Workplaces

Toward rapid silica analysis of CPDM samples: Deposition of recovered dust and analysis by FTIR

Analysis of Crystalline Silica Aerosol Using Portable Raman Spectrometry: Feasibility of Near Real-Time Measurement.

Functional MCFe@PTFE Filters for the Catalytic Oxidation of PCDD/Fs at Low Temperatures

Aerosol Analysis Using Handheld Raman Spectrometer: On-site Quantification of Trace Crystalline Silica in Workplace Atmospheres

Aerosol Analysis Using Quantum Cascade Laser Infrared Spectroscopy: Application to Crystalline Silica Measurement

Improvement of Heat Dissipation in Ag/Ni Substrates for Testing Cu-TiO2/TiO2-Modified Filters Using SERS Spectroscopy

Nano-structured Calcium Silicate Hydrate-Based Composites Derived from Fluosilicic Acid for Highly Efficient Cr(III) Removal and Methylene Blue Degradation from Wastewater

Enhanced photocatalytic Cr(VI) degradation and real-time detection using dual-fluorescent quantum dot-infused polysulfone microspheres

Development of free flowing granular hybrid functionalized clay sorbent filters for chromium removal from waste water

A Novel Calibration Method for the Quantification of Respirable Particles in Mining Scenarios Using Fourier Transform Infrared Spectroscopy

A polyfunctionalized carbon framework composite for efficient decontamination of Cr(VI) and polycyclic aromatic nitrides from acidic wastewater

Enhanced removal of hexavalent chromium from aqueous media using a highly stable and magnetically separable rosin-biochar-coated TiO2@C nanocomposite

H 2 -Based Membrane Catalyst-Film Reactor (H 2 -MCfR) Loaded with Palladium for Removing Oxidized Contaminants in Water

Direct-on-Filter FTIR Spectroscopy to Estimate Calcite as A Proxy for Limestone ‘Rock Dust’ in Respirable Coal Mine Dust Samples

Synergetic Adsorption-Photocatalysis Process of Titania-Silica Photocatalysts and Their Immobilization on PEEK Nonwoven Filter for VOC Removal

One-step Fabrication of Oxygen Vacancy-Enriched Fe@Ti/C Composite for Highly Efficient Degradation of Organic Pollutants Through Persulfate Activation

From Rice Husk Ash to Silica-Supported Carbon Nanomaterials: Characterization and Analytical Application for Pre-Concentration of Steroid Hormones from Environmental Waters