Pt Nanoparticles in Cooperation with Mn-P Composite Drive Base-Free Selective Oxidation of 5-Hydroxymethylfurfural

Qinggao Hou,Tianyu Gao,Hao Zhang,Qinghu Tang,Wenhao Fang
DOI: https://doi.org/10.1016/j.cattod.2024.114990
IF: 5.3
2024-01-01
Catalysis Today
Abstract:Selective oxidation of 5-hydroxymethylfurfural (HMF) to 2,5-furandicarboxylic acid (FDCA) is a key approach to sustainable upgrading of furfural based biomass resources. In this work, small Pt nanoparticles (about 2.1 nm) loaded on MnPnOx composite were shown to effectively drive the base-free aerobic oxidation of HMF to FDCA in water. Regulating the P content in carrier enabled to tune HMF conversion and product distribution. The optimal Pt/MnP0.5Ox catalyst can reach 98% yield of FDCA at 110 degrees C under 10 bar of O2 after 24 h. It also showed the highest initial conversion rate of HMF (13 mmol molPt- 1 s- 1) and productivity of FDCA (4.1 mmol molPt-1 h- 1) among all the Pt/MnPnOx catalysts. The carrier effect of P addition on promoting Pt oxidation catalysis was elucidated by using rigorous kinetic investigations and comprehensive characterizations. The initial conversion rate, rate constant and apparent activation energy were independently measured on oxidation of HMF and its derived intermediates. ICP-MS, XRD, TEM, H2-TPR, O2-TPD and XPS were used to acquire catalytic properties. It was demonstrated that P addition led to changes in carrier structure and metal-support interaction, which eventually promoted the formation of highly active electron-rich Pt0 sites and mobile reactive defect oxygen species. These features allowed improving the selective oxidation catalysis of supported-Pt nanoparticles for the base-free conversion of HMF to FDCA.
What problem does this paper attempt to address?