Abstract:Crude oil fouling models have greatly improved in the past two decades. However, most models focus on the deposition of organic species at high temperatures (i.e. greater than 200 °C). In this paper, a deposit model, capable of capturing simultaneously the deposition of both organic and inorganic species, is used to track deposition history in a shell-and-tube heat exchanger at the hot end of a refinery pre-heat train. The model was previously fitted to plant data and the results compared to the experimental characterization of deposits. It is shown that such a model, together with plant data, can be used (i) to describe the development of complex deposit layers; (ii) to detect and diagnose changes in composition of the deposit. From a practical perspective, it is then possible to alert plant operators of unexpected events such as breakthrough of inorganics at an early stage and help in planning corrective actions.

Corrigendum to Study on the Heat Transfer Characteristics of CO2 and Liquid Desiccant CaCl2 Aqueous Solution in the Gas Cooler and Evaporator (vol 197, 108830, 2024)

Erratum: Central mean temperature scaling in compressible turbulent channel flows with symmetric isothermal boundaries [Phys. Rev. Fluids <b>7</b> , 044606 (2022)]

Correction: Hydrophobic Pillared Square Grids for Selective Removal of CO2 from Simulated Flue Gas.

Reference temperature correction and dimensionless number analysis for heat transfer of supercritical CO2 in horizontal tubes

Corrigendum to "High-resolution mapping of vehicle emissions in China in 2008" published in Atmos. Chem. Phys., 14, 9787–9805, 2014

Author Correction: Molecular Basis for Heat Desensitization of TRPV1 Ion Channels

Correction to "Heat Transfer by Sweat Droplet Evaporation"

Correction: Solid-state cooling: thermoelectrics

Corrigendum to “simulation of Cohesive Particle Motion in a Sound-Assisted Fluidized Bed” [powder Technology 207 (2011) 65–77]

Corrigendum: A CFD numerical simulation of particle deposition characteristics in automobile tailpipe: power abatement pathways

Corrigendum on “experimental study and thermodynamic modeling of a novel heat resistant explosive in different mono solvents”

Comments on “Corrigendum to ‘Thermodynamic solubility of tetraethyl ranelate in ten organic solvents at different temperatures. [J. Mol. Liq. 216 (2016) 771–780]’”

Erratum: Hu Et Al. Numerical Investigation of Flow and Heat Transfer in a Rotor-Stator Cavity with Centripetal Carbon Dioxide Through-Flow. Energies 2019, 12, 2613

Corrigendum to: "Entropy Scaling-Based Correlation for Estimating the Self-Diffusion Coefficients of Pure Fluids"

Erratum: “Thermodynamic effects at Venturi cavitation in different liquids” [Phys. Fluids <b>34</b>, 083310 (2022)]

Correction: Corrigendum: Autophagy-associated alpha-arrestin signaling is required for conidiogenous cell development in Magnaporthe oryzae

Erratum to "comparison of Repeated Fluid-Air Exchange and Passive Drainage for Removing Residual Emulsified Silicone Oil Droplets".

Simulation of cohesive particle motion in a sound-assisted fluidized bed (vol 207, pg 65, 2011)

Corrigendum to "Effect of Sc contents on the mechanical properties and damping capacity of Al-Zn-Mg-Cu-Zr-Sc alloys with different grain structures" [Heliyon 10(2) January 2024 e24428]

Erratum: “Transition to chaos in electro-thermo-convection of a dielectric liquid in a square cavity” [Phys. Fluids 32, 013106 (2020)]

Corrigendum to “experimental and Numerical Studies of Heat Transfer and Friction Factor of Therminol Liquid Phase Heat Transfer Fluid in a Ribbed Tube” [appl. Therm. Eng. 95 (2016) 165–177]