Abstract:This article introduces a small microwave remote sensing satellite weighing 310 kg, operating in low earth orbit (LEO). It is equipped with an X-band synthetic aperture radar (SAR) antenna, capable of a maximum imaging resolution of 0.6 m. To achieve the objectives of lower cost, reduced weight, minimized power consumption, and enhanced temperature stability, an optimized thermal design method tailored for satellites has been developed, with a particular focus on SAR antennas. The thermal control method of the antenna is closely integrated with structural design, simplifying the thermal design and its assembly process, reducing the resource consumption of thermal control systems. The distribution of thermal interface material (TIM) in the antenna assembly has been carefully calculated, achieving a zero-consumption thermal design for the SAR antenna. And the temperature difference of the entire antennas when powered on and powered off would not exceed 17 °C, meeting the specification requirements. In addition, to ensure the accuracy of antenna pointing, the support plate of antennas requires stable temperature. The layout of the heaters on the board has been optimized, reducing the use of heaters by 30% while ensuring that the temperature variation of the support board remains within 5 °C. Then, an on-orbit thermal simulation analysis of the satellite was conducted to refine the design and verification. Finally, the thermal test of the SAR satellite under vacuum conditions was conducted, involving operating the high-power antenna, verifying that the peak temperature of T/RM is below 29 °C, the temperature fluctuation amplitude during a single imaging task is 10 °C, and the lowest temperature point of the support plate is 16 °C. The results of the thermal simulation and test are highly consistent, verifying the correctness and effectiveness of the thermal design.

Design Optimization of Signal Timing for Multimode Integrated Microwave Remote Sensors

Leveraging Parallel Speedup for Intelligent Design of Metasurface

Design of Double-Mode Integrated Microwave Remote Sensor for Ocean Wave Observation

Research on the Parameter Design Method and System Simulation of Multimode Microwave Remote Sensors Operating in Scatterometer Modes

A Multi-Objective Intelligent Optimization Method for Sensor Array Optimization in Distributed SAR-GMTI Radar Systems

Efficient Design for NOMA Enabled Integrated Sensing and Semantic Communication

Multi-Disciplinary Design Optimization of Ocean Satellites Based on Analytical Target Cascading Strategy

Optimization methodology for structural multiparameter surface plasmon resonance sensors in different modulation modes based on particle swarm optimization

Application of Multidisciplinary Design Optimization to a Resource Satellite

Modeling and collaborative optimization of remote sensing satellite system parameters design

Optimization of Embedded Sensor Placement for Small Satellites

Design of Experiment Method for Microsatellite System Simulation and Optimization

Optimization strategy of active thermal control based on Kriging metamodel and many-objective evolutionary algorithm for spaceborne optical remote sensors

Discussion on Modeling and Multidisciplinary Design Optimization for the Satellite System Parameters

Radiometric Sensitivity and Angular Resolution Optimization of Thinned Linear Arrays in Microwave Interferometric Radiometry

Optimization of parameters of attitude determination system of micro-core

A Parameter Optimization Model for Geosynchronous SAR Sensor in Aspects of Signal Bandwidth and Integration Time

Advanced Design and Optimization of Large Scale Microwave Devices

An Optimization Method of Overall Design in Small Long-endurance Solar Powered UAV

The optimization design of earth observation small satellites using particle swarm Collaborative optimization design method

Thermal Optimization Design for a Small Flat-Panel Synthetic Aperture Radar Satellite