On Perpendicular Curve-Based Task Space Trajectory Tracking Control with Incomplete Orientation Constraint.
Gaofeng Li,Shan Xu,Dezhen Song,Fernando Caponetto,Ioannis Sarakoglou,Jingtai Liu,Nikos G. Tsagarakis
DOI: https://doi.org/10.1109/tase.2022.3183079
IF: 6.636
2022-01-01
IEEE Transactions on Automation Science and Engineering
Abstract:The Incomplete Orientation Constraint (IOC), which does not require a controlled motion constrained by all three spatial directions, exists widely in a lot of robotic tasks. However, the IOC remains a challenge for existing methods, due to the nonlinear structure of the rotation group SO(3). Moreover, the IOCs are time varying in the trajectory tracking problem, which makes it more challenging than the set-point control. To address the IOC problems, we define, identify and prove the closed-form solution of the perpendicular curve in SO(3). Based on the proposed perpendicular curve, we develop a new trajectory tracking controller considering the IOC. Compared with existing methods, the proposed method can achieve faster and more accurate tracking results. Moreover, the proposed method can be applied not only to manipulators with redundancy (including both functional and intrinsic redundancy), but also to manipulators that are non-redundant. Furthermore, it is easier to incorporate a secondary optimization objective into consideration for the intrinsic redundant case, which is difficult for existing methods. The proposed method has been implemented on both simulations and experiments. The numerous simulation and experimental results validate the effectiveness and advantages of the proposed method. Note to Practitioners—The trajectory tracking control with IOC is important and can be applied in a wide spectrum of robotic-assisted manufacturing, e.g. arc-welding, engraving, etc.. In this paper, a perpendicular curve-based trajectory tracking method is proposed to consider the IOC automatically. It is no longer necessary to carefully plan a reachable orientation trajectory. Users only need to focus the planning of the tool direction, which is determined by the tasks. In addition, the proposed method can achieve faster and more accurate tracking result. Moreover, it is universal and can be applied to both redundant and non-redundant cases.