Abstract:The organic Rankine cycle (ORC) system can effectively recover waste heat from engines of heavy-duty trucks, and is a promising method to improve the efficiency of on-board engines. However, engine operating conditions fluctuate greatly while driving, the waste heat recovery system must often work under off-design conditions, which significantly affects system performance. Further, different component structures can also affect the off-design performance of the system. Thus, a novel design method of preheating organic Rankine cycle (P-ORC) system harvesting waste heat of heavy-duty trucks based on off-design performance is proposed in this study. The design method includes selection of the optimal types of components and design point to optimize the comprehensive performance of the waste heat recovery system in all road conditions. In this study, different heat exchanger combinations are applied to the P-ORC system to obtain six different design systems. According to the principle of uniform coverage, the scatter diagram of exhaust temperature and mass flow rate of the engine under real road conditions are discretized into 19 alternative design points. Each system is designed with 19 discretized design points, and a total of 114 design systems are obtained. The optimal heat exchanger combination and design point are selected based on the off-design performance. It is concluded that a P-ORC system using a combination of plate preheater, finned tube air cooler, and shell-tube evaporator is the optimal system. The optimal design point number is 10, and the corresponding engine speed at DP10 is 1471 rpm, the engine torque is 474 Nm, the occurrence probability is 14.48%, the exhaust temperature is 350 degrees C, the exhaust mass flow rate is 0.11 kg/s, and the maximum combined net power output is 4.26 kW. The results reveal that the optimal design point of the system can be selected at the design point with medium engine load and high occurrence probability. It guides the system design toward a more practical direction, so as to obtain an optimal system that could operate efficiently and recover more waste heat under the full working conditions of the engines. This novel design method can be extended for other cycle configurations.

Achieving Effective Engine Thermal Management and Waste Heat Storage Utilisation by Coupling the Dual-Pressure Organic Rankine Cycle System with Hybrid Electric Truck

Achieving reasonable waste heat utilization in all truck operating conditions via a dual-pressure organic rankine cycle and its operating strategy

Experimental Investigations on Dynamic Performance of Organic Rankine Cycle Integrated with Latent Thermal Energy Storage under Transient Engine Conditions

Simultaneous Optimization of a Heat Exchanger Network and Operating Conditions of Organic Rankine Cycle

Quantitative Analysis of Fuel‐saving Potential for Waste Heat Recovery System Integrated with Hybrid Electric Vehicle

Optimizing Hybrid Electric Vehicle Coupling Organic Rankine Cycle Energy Management Strategy Via Deep Reinforcement Learning

Energy Efficiency Improvement of Battery Powered Wheel Loader with an Electric-Hydrostatic Hybrid Powertrain

Performance Simulation Of An Integrated Organic Rankine Cycle And Air Inter-Cooling System For Heavy-Duty Diesel Truck Engines

Improving Wheel Loader Energy Efficiency with a Series Electric Hybrid Powertrain

Energy Management Of A Dual-Engine System For Hybrid Heavy-Duty Vehicles

A Novel Design Method of Organic Rankine Cycle System Harvesting Waste Heat of Heavy‐duty Trucks Based on Off‐design Performance

An Electric-Hydraulic Hybrid Wheel Loader with Mode-Driven Control Strategy

Road Applicability of Hybrid Electric Vehicle Integrated with Waste Heat Recovery System

Cooling Performance and Optimization of a Thermal Management System Based on CO2 Heat Pump for Electric Vehicles

Research on the configuration design and energy management of a novel plug-in hybrid electric vehicle based on the double-rotor motor and hybrid energy storage system

Optimization-Based Energy Management Strategy for a 48-V Mild Parallel Hybrid Electric Power System

Potential of Carbon Dioxide Transcritical Power Cycle Waste-Heat Recovery Systems for Heavy-Duty Truck Engines

Dynamic Analysis of Refrigerated Truck Integrated with Combined Cooling and Power Cycle under Various Driving Conditions

Optimal Energy Control Strategy Design for A Hybrid Electric Vehicle

Power Distribution Strategy of a Dual-Engine System for Heavy-Duty Hybrid Electric Vehicles Using Dynamic Programming

Hierarchical energy management strategy for plug-in hybrid electric powertrain integrated with dual-mode combustion engine