Abstract:Ambient desorption/ionization mass spectrometry (ADI-MS) is widely used as a rapid screening tool of samples in their native state without sample preparation. While analysis times are much less than 1 min per sample, one challenge of ADI-MS is the possibility to perform quantitative analysis of analytes in complex matrices. Typically, the goal is to probe a variety of different analytes in a complex matrix from a solid, liquid, or otherwise uncharacterized surface in the open air in front of the MS inlet. In this study, it is demonstrated that a carefully selected surface for analyte spot sampling and co-deposited isotopically labeled standards both significantly improve the capabilities of flowing atmospheric-pressure afterglow (FAPA) high-resolution (HR) MS for direct quantitative analysis. Specifically, a systematic study of different surfaces (glass, steel mesh, high-performance thin-layer chromatography (HPTLC) stationary phases including silica, reversed-phase (RP)-modified silica, and cyano (CN)-modified silica) and their suitability for spot sampling with FAPA-MS was performed. A set of different caffeine-containing standards and beverages (Red Bull, Coca-Cola, coffee, and black tea) was deposited on the surfaces and direct FAPA-HR-MS analysis of caffeine was performed using internal calibration with co-deposited 13C3-caffeine. For TLC surfaces, it was demonstrated that quantitative results could be achieved with the matrix and concomitants present and that a preceding chromatographic separation was not mandatory for this application. In addition, the use of a CN-HPTLC surface resulted in a significantly more intense caffeine signal in the beverage samples compared to the other surfaces studied, with the highest increase compared to the silica (200-fold higher) and the lowest increase compared to the steel mesh (30-fold higher). The utilization of TLC-based surfaces as sample carriers is considered an attractive tool in the ADI-MS toolbox for fast and efficient mass spectrometric investigations of complex samples without time-consuming sample preparation.

Nylon 6 Film Coated with Poly-Tetrahydrofuran Sol–gel Solution in Face Mask As a Non-Invasive in Vivo Sampling Device for Caffeine in Human Exhaled Breath Aerosol

Solid Phase Microextraction for Analysis of Alkanes and Aromatic Hydrocarbons in Human Breath

Detection of Caffeine in Xinyangmaojian Tea by an Electronic Nose

Study of a molecular imprinting polymer coated BAW bio-mimic sensor and its application to the determination of caffeine in human serum and urine.

Quantitative detection of caffeine in beverages using flowing atmospheric-pressure afterglow (FAPA) ionization high-resolution mass spectrometry imaging and performance evaluation of different thin-layer chromatography plates as sample substrates

Simple and environmental friendly procedure for the gas chromatographic-mass spectrometric determination of caffeine in beverages.

Caffeine Quantification in Dietary Supplements Using High-throughput On-line Solid Phase Extraction Coupled to Venturi Easy Ambient Sonic Spray Ionization Mass Spectrometry

Rapidly colorimetric detection of caffeine in beverages by silver nanoparticle sensors coupled with magnetic molecularly imprinted polymeric microspheres

Polyurethane-based face mask as a sampling device for environmental tobacco smoke

A New Caffeine Detection Method Using a Highly Multiplexed Smartphone-Based Spectrometer

In Situ Collection and SERS Detection of Nitrite in Exhalations on Facemasks Based on Wettability Differences

Chemical nanosensors based on molecularly-imprinted polymers doped with silver nanoparticles for the rapid detection of caffeine in wastewater

Nafion/Multi-Wall Carbon Nanotubes Composite Film Coated Glassy Carbon Electrode for Sensitive Determination of Caffeine

Capture and Analysis of MDMB-4en-PINACA and ADB-4en-PINACA in Exhaled Breath Using Functionalized Cotton Fiber: A Novel Approach to Noninvasive Drug Abuse Detection

Sensitive Differential Pulse Stripping Voltammetry Of Caffeine In Medicines And Cola Using A Sensor Based On Multi-Walled Carbon Nanotubes And Nafion

Determination of Caffeine and Its Metabolites Simultaneously in Vivo by HPLC and Used for Enzyme Assays on Pharmacological Study

Visual paper-based sensor for the highly sensitive detection of caffeine in food and biological matrix based on CdTe-nano ZnTPyP combined with chemometrics

Facile Preparation of Dual-Shell Novel Covalent-Organic Framework Functionalized Magnetic Nanospheres Used for the Simultaneous Determination of Fourteen Trace Heterocyclic Aromatic Amines in Nonsmokers and Smokers of Cigarettes with Different Tar Yields Based on UPLC-MS/MS

UPLC-MS/MS Method for the Simultaneous Quantification of Caffeine and Illicit Psychoactive Drugs in Hair Using a Single-Step High-Speed Grinding Extraction – Insights into a Cut-off Value for Caffeine Abuse

Wearable sampling of proteins from human exhaled aerosols for nano‐liquid chromatography–tandem mass spectrometry analysis: A pilot study

Nitrogen-doped Carbon Nanotubes Decorated Poly (L-Cysteine) As a Novel, Ultrasensitive Electrochemical Sensor for Simultaneous Determination of Theophylline and Caffeine