Abstract:Bridges crossing active faults are more likely to suffer serious damage or even collapse due to the wreck capabilities of near-fault pulses and surface ruptures under earthquakes. Taking a high-speed railway simply-supported girder bridge with eight spans crossing an active strike-slip fault as the research object, a refined coupling dynamic model of the high-speed train-CRTS III slab ballastless track-bridge system was established based on ABAQUS. The rationality of the established model was thoroughly discussed. The horizontal ground motions in a fault rupture zone were simulated and transient dynamic analyses of the high-speed train-track-bridge coupling system under 3-dimensional seismic excitations were subsequently performed. The safe running speed limits of a high-speed train under different earthquake levels (frequent occurrence, design and rare occurrence) were assessed based on wheel-rail dynamic (lateral wheel-rail force, derailment coefficient and wheel-load reduction rate) and rail deformation (rail dislocation, parallel turning angle and turning angle) indicators. Parameter optimization was then investigated in terms of the rail fastener stiffness and isolation layer friction coefficient. Results of the wheel-rail dynamic indicators demonstrate the safe running speed limits for the high-speed train to be approximately 200 km/h and 80 km/h under frequent and design earthquakes, while the train is unable to run safely under rare earthquakes. In addition, the rail deformations under frequent, design and rare earthquakes meet the safe running requirements of the high-speed train for the speeds of 250, 100 and 50 km/h, respectively. The speed limits determined for the wheel-rail dynamic indicators are lower due to the complex coupling effect of the train-track-bridge system under track irregularity. The running safety of the train was improved by increasing the fastener stiffness and isolation layer friction coefficient. At the rail fastener lateral stiffness of 60 kN/mm and isolation layer friction coefficients of 0.9 and 0.8, respectively, the safe running speed limits of the high-speed train increased to 250 km/h and 100 km/h under frequent and design earthquakes, respectively.

Statistical Running Safety Analysis of High-Speed Trains on Beam Bridges after Long-Term Service

Effect of Long-Term Bridge Deformations on Safe Operation of High-Speed Railway and Vibration of Vehicle–Bridge Coupled System

Running safety and seismic optimization of a fault-crossing simply-supported girder bridge for high-speed railways based on a train-track-bridge coupling system

Effect of Lateral Deformations of a Simply-Supported Beam Bridge on High-Speed Railway Traffic Safety under Earthquake Action

Effect of Bridge Pier Deformation for High Speed Railway with Ballastless Track on Train Running Safety and Comfort

Dynamic Analysis Of Train-Bridge System Subjected To Vehicle Collision

Dynamic Analysis of A Coupled High-Speed Train and Bridge System Subjected to Collision Load

Running Safety Analysis Of High Speed Trains On Bridges During Earthquakes

Assessing running safety of high-speed trains on long-span cable-stayed bridges based on in-situ monitoring data

A novel evaluation of train running safety on the HSR bridges under earthquakes based on the observed track deformation rate

Effects of Pier Deformation on Train Operations within High-Speed Railway Ballastless Track–Bridge Systems

Impact of vertical girder deformations on the high-speed train operation performance

Effect of track defects on track deformations for high-speed railway bridge

Dynamic Analysis of a Train-Bridge System under Vessel Collision and Running Safety Evaluation of Its High-Speed Train

Analysis on the Dynamic Response and Running Safety of 96 M Steel Box Tied Arch Bridge

Lateral girder displacement effect on the safety and comfortability of the high-speed rail train operation

Running Safety Analysis of Trains Passing over Bridge during Earthquake

Analytical evaluation of the influence of vertical bridge deformation on HSR longitudinal continuous track geometry

Investigating the Impact of Typical Bridge Transverse Dislocations on the Running Performance of High-Speed Trains

Creep Effect on the Dynamic Response of Train-Track-Continuous Bridge System

Dynamic Performance Evaluation of a High-Speed Four-Track Railway Bridge Traversed by Multiple Trains