Study on Shear Mechanical Characteristics of Rock Joints under Different Anchorage Lengths

Sunhao Zhang,Yujing Jiang,Hengjie Luan,Bo Li,Jianrong Liu,Changsheng Wang

DOI: https://doi.org/10.1007/s00603-024-04075-2

IF: 6.518

2024-01-01

Rock Mechanics and Rock Engineering

Abstract:Understanding the shear characteristics and acoustic emission features of bolted joints is crucial for the optimization of support systems and disaster early warning. In this paper, a series of shear tests on rock joints using both full-length anchorage and partial anchorage methods were conducted. The evolving patterns of shear mechanical characteristics and acoustic emission features of bolted rock joints were obtained, elucidating the influence of anchorage methods and revealing the shear failure mechanisms of joints under different anchorage lengths. The results indicate that the “pin effect” of the bolt can be rapidly mobilized in the full-length anchorage compared to the partial anchorage method. The full-length anchorage exhibits higher peak shear stress and fracture shear stress, with maximum differences of 0.38 MPa and 0.08 MPa, respectively, when contrasted with the partial anchorage method. The deformation range of bolts in the partial anchorage method approximately doubles that observed in the full-length anchorage. Acoustic emission feature parameters exhibit a good correspondence with shear stress curves, and their evolution suggests that the most significant damage to bolted joints occurs at the shear stress peak, with the highest energy release observed when bolts fail. Under both partial anchorage and full-length anchorage, with an increase in normal stress or JRC, the b of bolted joint acoustic emissions gradually decreases. Compared to the partial anchorage method, the full-length anchorage demonstrates a higher maximum Hit rate, along with lower maximum energy release, implying more intense interaction between bolts and surrounding rock in the full-length anchorage, resulting in greater damage under the same conditions, whereas the deformation range of bolts is smaller, and the energy released upon failure is lower in the full-length anchorage.