Abstract:The micro-newton thrust generated by an ionic liquid electrospray thruster (ILET) can be used for drag-free control, attitude precise control, networking, and formation flight of micro-nano-satellites or spacecraft. Fabrication of high-quality emitters is one of the key technologies for the application of ILETs. A new method for fabricating externally wetted emitters is presented in this article. This method uses low-speed wire cutting (LSWC) combined with electrochemical etching, and the externally wetted emitter is fabricated in three steps. First, the tungsten cuboid is shaped by LSWC to get the geometry of the emitter. Second, the emitter is cleaned by superacid to remove the oxide layer that critically prevents the ionic liquid from wetting the emitter. Finally, microchannels are etched on the emitter surface by electrochemical etching. The tungsten emitter fabricated by the above-mentioned steps can obtain excellent wettability, and its microchannel can reduce the contact angle between the wall and the ionic liquid and enhance the capillary force that promotes the ionic liquid to climb along the emitter. The ionic liquid is spread into a uniform liquid film on the emitter surface to ensure a stable and continuous flow supply so that the thruster can work in pure ionic emission mode for a long time with low noise, high resolution, and a high thrust power ratio. The quantitative and qualitative analysis of all elements before and after the pickling emitter proves the feasibility of removing the oxide layer. The morphology features of the emitter are measured and observed using a metallographic microscope and profilometer, including the microchannel structure and its size and tip size and the thickness of the liquid film. Through repeated observation and evaluation, the etching parameters are recorded, including the amplitude and frequency of AC voltage, the etching time, the depth of emitter immersion in the solution, and the concentration of NaOH solution. In order to compare the performance of an externally wetted emitter and a porous emitter, the same process is used to fabricate two kinds of emitters. The conclusions on beam current, the resolution and noise of beam current, ignition reliability, and emission time are summarized during the emission testing. The emission tests indicate that the externally wetted emitter exhibits outstanding performance, which depends on its better wettability and the fact that the microchannels are not easily blocked by the products of electrochemical reaction.

Molecular Dynamics Simulation on External Wetted Ionic Liquid Electrospray Considering the Asymmetric Wetting Behavior of Cations and Anions

Stable Single Device Multi-Pore Electrospraying of Polymeric Microparticles Via Controlled Electrostatic Interactions

Influence of electrical boundary conditions on molecular dynamics simulations of ionic liquid electrosprays

Modeling of an ionic liquid electrospray using molecular dynamics with constraints

Study on the electrowetting and beam current characteristics of externally wetted ionic liquid electrospray thruster

Ionic liquid electrospray behavior in a hybrid emitter electrospray thruster

Molecular dynamics simulation of ionic liquid electrospray: Microscopic presentation of the effects of mixed ionic liquids

Molecular Dynamics Simulations of Ion Extraction from Nanodroplets for Ionic Liquid Electrospray Thrusters

Molecular dynamics studies of ionic liquid-surface interactions for electrospray thrusters

Simulation of liquid meniscus formation in the ionic liquid electrospray process

Inferring electrospray emission characteristics from molecular dynamics and simulated retarding potential analysis

Multiscale modeling of electrospray ion emission

Electrospray beam currents in the cone-jet mode based on numerical simulation.

A Microfabricated Planar Electrospray Array Ionic Liquid Ion Source With Integrated Extractor

Prediction of fundamental properties of ionic liquid electrospray thrusters using molecular dynamics

Modulation of wetting state switching of droplets on superhydrophobic microstructured surfaces by external electric field

Simulation of Electrospray Emission Processes for Highly Conductive Liquids

Tuning the Internal Energy of Ions Produced by Atmospheric and High-Pressure Electrospray by Modulating the Gas Throughput into the First Vacuum Stage

Fabrication of externally wetted emitter for ionic liquid electrospray thruster by low-speed wire cutting combined with electrochemical etching